Watts SVGE10 Pre-Cut 3/8-Inch Diameter by 1/4-Inch Clear Vinyl Tubing, 10-Foot Length

Worked great for my application

I used this clear hose to replace the coolant on a Lexus RX350 with the 2GR-FE engine. It fits perfectly in terms of diameter and easily handles the temperature of hot coolant without any issues.

Used with sealing funnel kit, this allows bleeding air from the rear bank bleeder port when changing coolant in a toyota 2GR-FE V6 engine. Necessary to bleed all air from system to prevent coolant air pocket in the engine causing excessive heat build up and premature engine failure. Burping alone with the funnel kit will not clear air from rear cylinder bank

this is a fine, inexpensive tube. I wouldn't use it for food - it has a very plasticky smell and taste... Also, some are still shipped with a very sticky tape holding them looped. That tape is a mess to clean off. Otherwise, a fine tube for a little bit of money,,,

I needed to make a bleeder and this worked great.

Like others have said, this tubing fit over the F150 brake bleeder nipples firmly and snugly. No need for a crimp or zip tie. The tubing is firm or stiff enough that you can get aggressive with it to press firmly over the bleeder. It stays put. The tubing is certainly clear enough to easily see when the old brake fluid is displaced with new, saving you from wasting expensive fluids. Great product for brake bleeding.

The plastic tank which holds liquid dishwasher soap broke off the threading, which connected to the soap dispenser next to the kitchen sink. I was trying to figure out a way to support the plastic tank so it would not fall down and spill soap into the undersink cabinet. Then I figured that I could extend the pipe from the dispenser and supply liquid soap from its original Costco-sized container. With super glue, this vinyl tubing connected perfectly around the plastic tube connected to the dispenser. Now I seldom have to refill the soap dispenser because it feeds from a much larger container, and I don't need to worry about the small plastic tank falling and spilling soap.

This tubing looks to be some good quality material, rolled and bundled according to the length ordered. The tubing itself has no markings at all on it, except for "Do Not Use For Icemakers". But there is a nice adhesive label attached at one end with the Inner & Outer Dimensions. If you start your cuts on the opposite end, the tubing will always be labeled with the size.

It’s. Good it. Work my Jeep Cherokee trail hawk

Product as described.