15" x 18" RV Water Heater Black Door and Flange Combination

So Far So Good, simple install and it worked first pass, I took the original(only one year old) back to camper dealer and left it on their Entrance with a note to all customers on the Junk they put into Springdale campers and the lies the sales folks tell!!

Works great. Installed after our tank water heater busted. Used it everyday for six months no issue. Would buy again.

We replaced our tank heater with this in July and we lived in our RV until September it worked flawlessly. Will see how it does in the spring. It was easy to install and I like how easy it is to adjust temp.

I have upgraded from 1 to 4 stars, not for the product, but for the customer service I received. I did not make a mistake in ordering this door - The issue is the clarity of the listing. Maybe my case is the odd one, but it is the truth, and I had to change gears and improvise at the last minute. I did receive a refund, (Thank you KingRVer!) ORIGINAL REVIEW: The dimension width is 18.5” not 18. This made all the difference on my clients rig. Couldn’t install for that reason, as well as theis: the hole for the water heater IS NOT CENTERED!! It’s placed all the way to the right side, instead of being in the center. What an arbitrary decision. Makes no sense at all, and again, made it impossible to install in my clients coach. (The original water heater has rounded corners on the tank , of course. This tank is exactly square, and that square edge used up the space in the bottom corner inside the water heater compartment, and hit against a plumbing pipe. Would not work. If it were CENTERED, the fitment would have been almost perfect, except for the extra 1/2” on the door. Probably doesn’t make much sense what I’m typing but might possibly help someone to be aware of fitment. Now I’ll have to customs make a flange that will hold this water heater. (I do like the water heater though.)

Works perfectly, can have longer hot showers, great value for the money! Easy install!!

It does not work well at all. I did receive a new mother board. But it also does not work. The instructions say it works from 10 to 17 volts. I have tried 11.7 to 14 volts, correct and new propane and water psi and it has failed to work correctly since got it. I think Fogatti needs to take this one back to the drawing board.

This water heater was non-functioning from the start, but after a long process of troubleshooting, the company sent a new motherboard, and that fixed everything! I had my first hot shower in months, thank you.

So far it's great! Was a very snug fit and had to make a home Depot run for some fittings. Heats great finally a long hot shower! Now we wait to see how long it last and how much propane it uses.