Boat Blower Hose, 4 Inch Marine Exhaust Hose, 10 Ft Flexible PVC Duct for Bilge, Engine Compartment, Galley, Head, or Dryer Vent, White

Good product

You have to work on each end of the tube over the receptors, it is a tight fit. Have the claps loosely on the end of the tube until you get the tube attached, then move the clamp down and tighten it. Once it is on it works well.

Why did you pick this product vs others?: I really liked this stuff. The foil and PVC hybrid gives the benefits of both. Time will tell if it holds up. I might even get more for my RV furnace.

Great item

Easily installed on my 20 year old boat.

Very flexible looks pretty good black outside silver inner but very thin material hopefully it lasts

Very good quality better than the original

Know exactly what and where you wanna use it. myself have built a duct work system for my cvt clutches .

Works great. Saves me from running around looking for one.

👍

I haven't used the item yet . But it looks great

Great kit - more then enough hose to replace both the fan exhaust (from bilge to fan, from fan to exhaust port) and secondary exhaust vent on our SR1750. Only thing keeping this from five stars is it only comes with 2 clamps - which are top-notch quality - which for our application meant we needed to procure more. But would purchase again if the need arises.

Be aware! This product's diameter is NOT 3 inches. The diameter of the hose is in fact 3.5 inches. Don't be mislead!