ALLECIN 3W Metal Film Resistor Kit from 1 Ohm to 1M Ohm 25 Values 3 Watt 1% Resistors Assortment

These resistors test very well within their assigned resistance values. The wire leads are a little shorter than traditional carbon resistors but are usually long enough for most point to point wiring. Another plus is that the resistors are typically smaller and take up less real estate than traditional old style carbon resistors. I found the resistors to be quite accurate and function as designed. They are a good value for the money and great to have this kit on my parts shelf. The color bands are a little difficult to read, so I recommend double checking the value with an ohmeter before installing. Also, they might not be suitable in some RF applications because they may add a small amount of inductance to the circuit.

This is a fine assortment of 5 watt, 1%, metal film resistors. 25 values, 5 each value. I was impressed by the super packaging and labeling. Each 5 piece value in its own plastic, seal top bag. The label with ohms value, wattage and tolerance is paper, glued to the outside of the bag and is perfectly legible. The 125 total pieces enclosed in a sturdy plastic, two tab locking box. So much better than when I ordered resistors direct from China as they were poorly marked and in flimsy, too small plastic bags. I will be investigating other resistor assortments from this Amazon seller.

No issues good quality

I only measured a few, and most are within tolerance but some were not (though not far off). No issue for my application, but I’d treat them as 5% resistors rather than 1% to be safe. Still giving 4* based on value for money.

This small compact box contains just about any value of 1% 1/4W resistor you are likely to need. Ten resistors of each value are fixed on a section of a strip of reel tape with the specific value printed on. This makes for a much more compact way of storing your resistors compared to the old sectioned pull out drawers which take up space and have a tendency to tip over and spill out everything. The selection is good for finding which values you are going to use the most so later you can order of just those values that you need the most.

definitely good

Nice variety and quality of commonly used resistors. But as I needed only two resistors for my power-supply project, a much smaller assortment would have better suited my needs. I will never use 99% of them. But nonetheless, it was an excellent buy.

Good pack for building up bench stock of lots of different values. Been using them to breadboard DIY guitar pedals. The leads are really really thin, not as thick as the other pack of resistors I got in a different kit. But it will be fine when I start soldering. They are a little thin for breadboarding.