SUP Pump Adaptor Inflatable Boat Air Pump Air Valve Adapter Kit Paddleboard Air Nozzle Multifunctional Conversion Head Air Adapter with 4 Air Valve Nozzles

Great for any paddle board that has proper adapter allows you to put more air than the high flow low pressure pump alone

We purchased standup paddle boards and we love them, but they are very difficult to inflate. It takes a long time. I purchased this adapter and was super happy with the results. I plug it into my inflator and I just wait rather than having to pump everything manually which took over a half hour. I wish I purchased them sooner.

Does not work for Aqua pool float with large Duolock valve. The quarter size adapter is not deep enough to fit into the valve. See picture.

The adapter to go from sup manual pump hose works good. Included are a few adapters that then can be used to blow up tubes, mattresses etc. what would make it perfect is an adapter to accept screw in electric air pump adapters.

I bought a portable, electric air pump and needed an adaptor to be able to use it on my paddleboard. These work great and now I have options for various things that may come up.

love that all the attachments are together so you do not lose any. Very useful and practical. Variety of nozzles for whatever you need to pump!

So, i purchased this specific product vs others, due to the additional adapters that are included. Since I have a inflatable kayak that uses boston valves and would be nice to have alittle more pressure in it.First off, you've got to realize what you are using here. Most inflatable kayaks and SUPs need alot of air. if you use a high pressure, low volume pump (like for a tire) you will be there....a looooooooong time. It's possible to burn out your pump. So ideally, use something with higher volume, lower pressure to pump it up to ~1psi. then swap to this to get to pressure. There's a reason that there are purpose made SUP pumps that have high volume low pressure / high pressure two stage systems.So the HR connection itself. It may be an issue with my pump, but when I used this adapter my pump showed 4 PSI and no change. When I hooked up my purpose made iSUP pump, it was up to 7PSI. Since the target number is 6, this is alittle...not dangerous, but could be damaging to whatever you are inflating.Still, that's probably not the fault of this valve, but a result of using an adapter with something it's not really made to do.The reason i returned this is all the connections. You use the Halkey Roberts connection to "twist" in to the connections, so you can use it with a boston valve, or others. The problem is that the rubber washer on the HR valve is too large. You can't turn it to seal then (or get the teeth of the HR connector to connect). Turn it too hard, and you twist off the glue holding the accessory together. take off the washer, and it connects fairly well. but at that point you are no longer air-tight.

Thw adapter made it easier to pump up paddleboards Now I can use a cheap pump. Not a high end pump.