Dremel EZ511HP 180 & 280 Grit Finishing Abrasive Buffs

I find they wear out a bit sooner than I'd like, but them's, as they say, the breaks. That said, they're not really expensive, and they work a treat. -- Recommended.

GREAT!

I burnt a stainless steel pot. I used this to refinish the inside. It did a great job. Of course you would never use it if your pot has any other type of coating.

I needed to polish some old pieces of metal art that were in a garage for a while. I probably went through about 30 or more of these abrasive heads for the Demel because they tended to wear out quickly. They work well, but just did not last long for this particular job.

I have purchased others that were more and less money that pretty much fell apart but these were excellent. I have a good life for the amount of use that I use them for and the price is still affordable. I highly recommend these over the higher quality quantity and lower quality ones.

The darker colored bits were defective in both packages I received. One did not have the ez connection portion attached, so I couldn’t use it at all. The other one’s ez connection came loose while I was working with it. Very disappointed.

These are for the Dremel and they work amazing.

Bad quality. Broke literally within seconds after first use. You would think that by buying original accessories from Dremel brand you would get decent quality. Searching for off brand stuff going forward.

I am terribly disappointed but its entirely my own fault. I did not read the description properly! You literally get one package of two pieces....the brown and the black one. $10 for one package......wow. Anyways....disappointed, but my own darn fault.

They are ok for softening up my wood carvings but didn’t last so I bought them in bulk package which was better but you will blow through them quickly if you’re using them as your main abrasive medium!!

Dont buy , better of subbing using dish rags and dollar store scrubbing pads , MAX life more like MAX death , just wanted to remove paint off trim ran at 1K rpm to 5K rpm to hope slow speeds wound not gunk up , ratter the drum sand paper did more damage to paint than this thing. (may be they will make 40 grit in the future but i wont hold my breath) might as well try the generic ones which come with the own shafts . Went to save garbage out of land fill but d

They work great but are over priced and don't last very long at all.