Adaptive Tactical Shotgun Receiver Mounted Shell Carrier Holds 6 Rounds of 12 Gauge Ammo

This was easy to install on my Maverick 88 and looks good. It seems secure and holds the shells in place. The instructions appeared to be a little different than the hardware that was included in the packaging, but it was easy to figure out and went on in minutes.

To hold extra shotgun shells when attached to receiver on shotgun

I took off one star because in the product video it shows the individual shell holders as a pliable rubber type material that the man sqeezes with his fingers. That is why I bought it but instead it is hard plastic with rubber fingers inside that hold the shells. It fits well, was easy to install and looks good. Holds shells tight. I cut a thin peice of cardboard as a gasket between the holder and the shotgun as suggested by another purchaser.

This is great because it works with the crimson trace side saddle laser, but the holes are really tight on the shells. You got to stretch it out and wiggle the shells to loosen it up so you’re not struggling to pull the shells out in an intense situation

Slots for shells are just not the correct diameter. Being 135lbs if I have to put the palm of my hand behind the shell, and have to force the shells in, no way to get them out easily under stress. That's not acceptable for my intended use. Was easy to install on 20" Mossberg 500

Good hardware. Bolts screw together rather than into the saddle like similar products that usually strip out. Wish the back had protective covering. I put ductape on mine. Metal on metal could cause scratches an rust.

Took less then 5 minutes to install on my 590A1. Seems to be made of Quality materials. Looks good.

Installation wasn't the easiest. One of the pins did not want to go in for some reason. Took me multiple tries and, what felt like, a lot more force than I should be using to get the pins in. After installing, I have taken the shotgun out to the range maybe twice. I noticed after that, one of the nuts was a little loose.Speaking of nuts, the item does not come with an adapter to tighten said nut so you better hope you have something that fits it. I don't know the measurement for this nut, I just ran around the house until I found something that fit (which in my case was a screwdriver with the bit taken out).The shell holder portion of this carrier is very tight. It takes a bit of time to take out a shell. Let's say it takes 5-7 seconds of fiddling with a shell in the carrier to take it out. I took some sand paper and vigorously tried to loosen the holes. Now it takes about 3-4 seconds to take out a shell with how tight it is. It's still tighter than I would like, but I don't feel like sanding down anymore.Looks great though. It also hides the serial number on mine which is either a pro or a con to different people.