TOGGLER SNAPTOGGLE Heavy-Duty Drywall Toggle Bolt – 3/16"-24 UNC Zinc-Plated Anchor for Hollow Walls, Plaster & Tile – Holds 238 lbs in 1/2" Drywall, Easy Install – 10 Pack (with Bolts)

Used these to mount my projector and they worked great. as long as you have the drill bit to make the hole, it was very easy to install - only took about 10 min to put up 4. they also seem very sturdy - my projector setup is at least 20lbs, and shows no signs of being loose or much less falling. great product

I used the TOGGLER SnapToggle to mount a cat playground, and it’s amazing! Super sturdy and secure—holds up even when my cats jump and climb all over it. Installation was easy, and I feel completely confident in its strength. Highly recommend for any heavy-duty mounting!

Fast delivery and exactly as described. These are my go-to anchors for my handyman business. I use them to mount TVs, heavy artwork, mirrors, vanity cabinets and sometimes curtain rods. They are super strong and reliable and in my opinion, there's no better anchor available anywhere.

After reading the reviews I felt confident in using them to install a grab bar in my bathroom. I read the instructions and got to work. I installed them, but one I did not pull tight enough against the drywall before I snapped off the excess, so I had to push it through and sacrifice it to the drywall gods. Once you get the hang of them, they are easy to use. I installed my grab bar just outside of the tub and it is very secure!!

These worked great to fix the included wall anchors that came with a wall mounted drying rack. The included anchors were useless but I had eight huge holes from using them. These worked great in the existing holes and the drying rack is now snug against the wall. I will definitely use them again and again!

These break very easily when installing. They break way before you need to break the guides off. I am barely positioning it and it breaks off. Be careful and make sure there’s ample room behind your drywall. Broke broke four before I even slid the locking ring down when positioning.

Already installed dozens of these, some I ended up buying locally. They really are good quality, easy to use and have a death grip hold . Helpful insight: Once in the wall, before pulling the tab into the hole , make sure the “legs” are equal, the peace inside the wall needs to be flat !, you can spin the “legs” around to find a flat spot as you won’t be able to get the bolt in on an uneven surface. If you mess up, use a small drill bit to take out the plastic sides (carefully) and start over. When you snap off the “legs” you might have some left over , use some pliers or channel locks with a flat surface , grab and twist off the remainder so you have a flat surface.

They work great but be sure of the size you use fasteners must pass through whatever your fastening to the wall.