Recessed Aluminum LED Profile with Frosted Diffuser - Recess Channel Extrusion with White Cover for LED Tape or Strip - Channel System for Under Cabinet, Shelf, Table | 2 Meters

Used with an LED strip, used a router to create a groove and slotted in nicely.

Not much to say other than these arrived exactly as advertised and have served their purpose well. The opaque diffuser works well to hide individual LEDs on a 120/meter strip, and dims the output by about 15-20% as expected. Very happy with this purchase, and good value.

This product is of good quality but it arrived out of shape , this happened during postage . In transit.

I have a dark kitchen corner with a low ceiling. While an LED light strip would be good enough to light up the space from above the strip itself doesn’t look good itself. Therefore I bought this to enclose the strip.It is very easy to install. It is so lightweight that I suspect you could fix it with just double side tapes. It come with ends on both sides and I can easily cut a larger opening on one of them to fit my thick light cable. The diffuser is pretty good in hiding the light strip but you shouldn’t have a wrong expectation that it can turn non-continuous LEDs to an even light output. You need to have COB kind of light strip to give the best result.

Did the job they were intended for and the colour looked good

I used the product to house a COB LED light strip in a diy driftwood lamp I was making. I had routed the slot to the measurements before buying it and was glad to see the duct was exactly the same width and depth. I glue it in place using epoxy resin glue. The defuser plastic clips in securely and is not likely to fall out. I only used a small amount of it so I have a lot left for other projects. Would definitely buy again.

Great product

I ordered the corner profile.Pros:Wide enough to accommodate Philips Hue positioned at 45 degrees.Lightweight - so likely to stay stuck.Cheap compared to some other options, and it looks good, but...Cons:Very soft and thin, which makes it easy to cut, but also high risk of accidentally bending/ kinking in transit or fitting.Very difficult to clip in the diffuser... very, very frustrating.No pre-drilled holes, and no adhesive it bends very easily