Youmile 2PCS L298N Motor Drive Controller Board DC Dual H-Bridge Robot Stepper Motor Control and Drives Module for Arduino Smart Car With Dupont Cable

Pretty good so far

Usee loads of these. This one was used in a blind raising system.

Arrived on time.No documentation provided and no links for such. However a google search will provide you with enough information to get going. No complaints with vendor, all units worked straight out of the box and the following comments apply to the module itself (irrespective of vendor).There is no provision for current sensing, which means you might have to drive your motors at a lower voltage than desired. When pulling 2A on each output, the module's heatsink does get very hot. Depending on use you may wish to add additional cooling.

I liked the fact that they are a better alternative to the Arduino Motor shield unit that I already have. It's much more compact and was better for use in my Arduino self balancing robot than the shield unit which has to plug on top of an Arduino Uno.

all 5 came in the package. tested out 1 of them so far and it works as intended.

Really worth the money it takes, all boards work well and have a small weight. Highly recommended stuff.

Combined mine with an elegoo uno and works great

Usati tanti per vari prototipi: compatto e robusto!

Tut was er soll

Le viti dei morsetti sono molto dure, difficili daAllentare e stringere. Per il resto tutto come daSpecifiche

Cumple mis expectativas, Facil de usar y robusto en su tarea de controlador de dos motores dc.

I did a small controller with a esp32 and using this board, and it works fine. With small heat sink is better if you are close to 2A. I posted the code in github with mi nickname Hpsaturn. The project is airobot.