JENOLITE Industrial Strength Paint Stripper Aerosol | Non-Drip Gel Formula | 400ml | Paint Remover and Varnish Stripper | Paint Stripper for Metal, Wood, Brick, Concrete

A second purchase for me.My mum painted the bathroom tiles, and immediately it required removal. Bad DIY decisions aside, she then attempted removal with nitromorse which stank and left green stains on the pvc.Now this stuff is easy to apply, works more or less instantly and took latex paint straight off the tile with minimal scraping.I would advise you cover any plastics, tape anything you dont want removed, and get a mask because this stuff works.

Worked great for pulling what I think is white emulsion and varnish from pine.My minor complaints are that it didn't go as far as I'd hoped, and the nozzle blocks constantly even following the instructions exactly to avoid it.I stripped a roughly 60 x 25 cm plank, both sides and edges, and one beam about 50 x 5cm, all sides again, and that was the can spent. It had to be applied quite thickly to really pull the paint up. I tried a thinner coat and it wasn't as effective and took some scraping for a messier result.The nozzle issue was solved with removing the cap every now and then and twiddling a safety pin in it to dislodge the residue.If I wasn't on a budget, I'd buy more and keep going but I'd need at least 2 more cans.... A bottle of stripper is more affordable at that point.

Worked well on a garage door, you just have to understand that you will need three cans for a single up and over door. Helped on its way with a disc sander, which also ruffed the metal so gave a better surface for the new coat to attach to.

I believe the product works well, albeit it does not strip underlying surface paints where there’s multiple layers. You’d need to reapply. I expected the can to last longer but it only did 1 sqm so it’s very expensive for how much it does and only strips the upper layer

The media could not be loaded. Excellent strength paint stripper. I ordered 2 cans to be on the safe side when removing paint from 4 18 inch allow wheels that'd previously been painted. Likely used 1.5 cans in total to complete the job.I recommend scraping/working the paint off after around 10 minutes, while the product is still wet. It can be a lot harder to remove once the product has dried.

Terrible didn't even manage to strip one door such a waste of money 🤦‍♂️ .... I don't know if I got a faulty or empty canister but it didn't last long

Last spring I acquired an aluminium table and then bought 2 chairs to go with it for a small seating area in my garden, all were covered in thick globby paint in white and green and I thought I could easily strip it... After hours with a wire brush and then with a drill attachment and then using paint stripper with very little success I gave up and ignored it until this summer. I contacted a local sand blaster and was quoted £100s to do the furniture which made my thrusting project pointless, could buy a dining room for the cost. I decided I would give it one more try and guided by my trusty AI friend, I found this product... And I am so over the moon, it is magic, getting in all the twisty bits, paint just falling away and then with minimum elbow grease getting every last bit out. I wish I knew about it last year. I should have my table and chairs ready for this weekend now as opposed to next year if I had continued at my previous pace.I will share more photos when I'm done!

⭐️⭐️ – Underwhelming Performance and Poor PackagingThis paint stripper has a very strong chemical smell, so make sure you’re using it in a well-ventilated area. Unfortunately, its actual effectiveness was underwhelming — it struggled to remove certain types of paint from metal surfaces, even after multiple applications.To make things worse, the cap broke after the first use, which made storage a hassle. Overall, it didn’t perform as expected and felt cheaply made. Wouldn’t recommend unless you’re working with very light-duty paint removal.