Niviy (Brick) - Privacy Window Covering Brick Stained Glass Window Film Waterproof Static Window Cling, 45cm by 200cm No Adhesive Glass Window Decor for Bathroom/Kids Room/Sliding Door, 1 Roll

I love this stuff! I’ve used it before, and a few years later have bought more. (of the same pattern) This picture doesn't do it justice. looks soooo good with bright daylight behind it. Super easy to fit, not messy or sticky at all. And easy peasey to remove.

Excellent privacy even with light on in the morning. The quality is superior to what I bought before on shein. Application is straight forward with instructions and tap to remove the solifan covering on the sticking side. Install it on windows from the inside.

In comparison to the reflective shade film I got at Walmart, this one is such a waste of money. The Walmart one blocks far more sunlight. It also stays on the window without adhesive. Installing it is dead easy as long as you measure the window and trim to size before putting it up. This one needs to be adhered to the window. It’s a sticker after you pull off the protective film. An incredibly thin, sticker that is bound to stick to itself in the process of installation, resulting in lots of creases. You might be thinking, “Well, maybe you just put it on wrong? Didn’t follow the instructions?” The first time I screwed up the adhesive from it sticking to itself. The second time I was methodical about it. I clung it to the window using just water to see if it would stay — it didn’t. The corner started lifting within a couple hours. I started unpeeling the protective film from the top right corner, just enough to get it to stick to the window in its already aligned position. Then I slowly peeled all across the top, again just enough to get the top edge to stick. The idea being that if I just slowly peeled the rest of it, it would 100% be smooth and aligned. Once I got the top edge down, I sprayed the window with water per the directions it came with and started peeling. Simultaneously while peeling, I had a squeegee making sure it was going down evenly. The water got trapped in the film instead and the film is so thin that trying to squeegee it out actually creased it permanently. It’s also so thin that it was entirely not aligned by the middle point because of how flimsy and bendy it is. Maybe it would’ve worked better if I hadn’t followed the instructions with the water? I’m keeping them up for now cause it’s better than nothing. Once the non-adhered ones fall off, I’ll be picking up more film at Walmart.

J'ai bien fait comme demandé et j'ai des bulles qui restent dans la fenêtre ! Dans le passé j'ai fait d'autres fenêtres avec le même produit et il n'y avait pas de bulles. Eau trop savonneuse ? Mauvaise batch? Je suis déçu ! ±++++++++ Après quelques jours, plusieurs bulles sont disparus ! ************

I installed this on my skylight and bathroom window. I love that it gives privacy but also still lets light filter in vs traditional darkening clings or shades. It was 70 degrees outside when I fitted it to the skylight and it would cling very easily when warm, I didn't even need to add water to the window but I did add small pieces of double-sided tape to secure the corners so gravity doesn't pull it down some day. The hardest part is making it perfectly flat without air bubbles or wrinkling. Make sure to measure and cut all the way to the window edges to avoid the natural window glass showing or else it makes it more obvious that the cling is fake.