Orion-Tr DC to DC Converter - 48/12-Volt 20 amp 240-Watt - IP43 Protected - for Dual Battery Systems - Isolated

This is a sturdy voltage converter/regulator and it works well for what I was designing. I've ran a 10 amp water pump on it for a while and it stayed cool. The terminals are rugged enough, it looks fairly water tight and works fine for my custom design which is to supply a full 13V DC level to a 12V sump pump on a 100A-Hr battery back up where I need it to lift water 10 feet over a basement wall if needed on big thunderstorms and the power went out. A photo is attached of what the assembly looks like with the same brand of battery charger added. I use a control block (circuit) with a water pump float switch as an input to activate the pump. The switch I use has a timer + a long-throw float switch so it runs long enough to drain the sump and will alarm if there was an issue of not pumping. The control signal goes to an optional input switch on the converter which only needs a few mA to set the output ON-OFF. or just jumper that if you want it to remain on. This is more robust and adjustable than any battery backup system I could have bought and I've had several which all failed after a while. Using the DC Converter plus a regulated DC charge controller gives full, adjustable control of the charge rate, final voltage levels and maintains the battery with intelligent battery levels over time. Commercial sump pump battery backup systems tend to overcharge the battery eventually which wrecks the battery and runs too slow when pumping. This setup is superior when coupled with an intelligent charge controller and the DC converter. This design allows a 12V DC pump to run at FULL speed at 12.8 - 13.5V if I want and turn off quickly rather than pumping slooooowly at 12V or 12.4 and run the battery down because it takes too long. This method runs the DC pump at FULL speed and shuts off quickly which is less draw on the battery overall. I added DC breakers for protection of the battery, the pump and for the DC converter. This setup also works if you need backup batteries from a 12V vehicle battery 50-100 feet away and the voltage drops over the long distance and ends up too slow to run a pump. You can give the converter 10V or whatever and it will still output a full 12.8V or whatever you set it to. Of course, energy is still energy so if you feed 10V in and want 12.8V out then the input current will be higher accordingly. My only complaint is the DC adjustment screw is TINY, recessed, hard to see and made of plastic which is hard to adjust. That is the weakest part so get a small screwdriver that fits well so it doesn't strip out the plastic screw. The rest is well made.

This item works great to control the voltage coming from the engine starting battery and charging my new lithium batteries. The charging voltage for the lithium batteries is 14.5 volts roughly and my typical charging voltage for the starting battery on my engine is only 13.9 volts coming out of the alternator. So I set this for 14.5 and it boosts the voltage. I have solar on these batteries for the house portion and it charges them at 14.6 volts and I don't want that voltage going back to my lead acid starting battery on the RV so this is called an isolator which keeps the voltage from going backwards. You cannot use a non-isolated DC to DC converter with different kinds of batteries like lead acid starting battery and lithium Coach side battery or house battery. Victron makes a great unit here and it is reliable. I install these on all of my new installations for solar and lithium conversion for RVs. It also limits the amperage because if you just connect an almost empty lithium battery of like say 300 amps it can try to suck 200 amps right out of your starting battery and out of your alternator which your wiring nor those batteries or alternator is designed for. So this brings it down to a less stressful amperage that can be handled with the standard alternator and lead acid starting battery and 4 a w g power wire that comes from the front of the RV back to the house batteries. You want to keep this limited to 40 amps and I usually just like to have a 20 or 30 amp DC to DC charger so that I don't stress out the vehicle's alternator on long trips or at night time when it needs it's power that is being produced by the alternator to run lights and such. If you go too many apps with this you can end up sucking more energy out of the battery and alternator especially at idle or low speeds and cause your battery to die and cause the engine to die since it is needing that voltage to keep the fuel pump and computer engine fan headlights heater or air conditioner going

First, this unit is not intended to be a DC to DC charger. You need to get the Orion-TR Smart to do that. That said, this is the highest quality DC to DC convertor you can buy. It's rugged and designed for mobile applications. I installed this in my house electrical system in my truck. This system is built around a secondary battery that is charged by solar and the alternator while driving. The Starlink Mini will run off 12v with the appropriate cable, but to use a long power cable without going to 10 awg wiring you need to bump the voltage up. The Orion-TR 12/24 accomplishes that. What sold me on this product was the ability to adjust it up to 30 volts. This is easy to do with a meter and a screw driver. 30 volts DC is what the OEM Starlink Mini 120v adapter puts out. I installed this unit, added a remote switch to be able to turn it on and off as needed, and built an outlet for the 5.5x2.1mm DC plug. Plug the OEM 15m cable in and you're off. It really is that simple.

Gave 4 stars because 1st one was not putting any amps out. Did a return request and second one works great. Put it right by lithium battery on trailer and used existing 7 way to power it. The first time I tried the next size up and it drew too much power and popped the vehicle fuse. This one works great with no problem. Very small and great cost. Did not need all the fancy features of the more expensive version.

Works as advertised but be aware this is the DUMB Orion and not the SMART Orion. This dumb Orion is not optimized for battery charging. It is merely a constant power transformer

As always, Victron stuff just works perfectly.

Cet appareil fonctionne bien. Je l’utilise comme convertisseur dc-dc alimenté par la batterie auxiliaire de mon VR. Je l’ai ajusté pour fournir 9A à 14.2V pour la recharge d’un bloc d’alimentation à batterie lithium.

Solo una parola, perfetto!

Många parametrar som går att ställa in. Laddar i mitt fall lifepo4 batteri. Supernöjd.

top

Veramente ottimo nulla di negativo da segnalare. Costa ma ne vale la pena