HUSUKU LED Marine Courtesy Lights, 316 Stainless Steel, 18LED IP65 Boat Transom Mount Waterproof Stern/Pontoon Lights 10-36V

Absolutely love the bright green led lights for my boy. These units are replacing the original clear lights. These lights were very easy to install and when I turned them on, WOW they are very bright. Now I’ll be ready for night fishing. Great product and will buy another unit to install in the back end of my boat where it’s dark.

I bought and installed these on my deck boat for interior lighting. They work very well and illuminate my boat VERY WELL! In hind sight, I think I would not have gone with the blue lighting that I bought, but that's on me, not the manufacturer. They work very well and I have not had any issues with them since they've been on my boat! I did seal around the bases with a bead of caulk to prevent water intrusion, and I think I would advise everyone to do the same to ensure they will last, but that is likely true of any lights used around salt water. All in all, very happy with them.

Bright transom light but the wires should be of larger gauge for the claimed lumens. The stainless steel bezel should not pit over years.

Wire is extremely small gauge for marine application. Lights are super bright & seemed to fit oem fairly good.

Perfect for what I needed and I spent too much time shopping and burning gas

First all wires very small. If you look at installation instructions you have to drill hole 2.20 inches round. Screw holes are 2.36 inches apart leaving only .16 inch to mount screws into for two sides. I made spacer rings 1/4 thick to raise light up so it became flush mount and to insure firm mounting. Used a plastic cutting board from discount retailers to make spacer, then used 2 1/2 inch hole saw till about half way through board then used a 2 1/4 inch hole saw to cut hole all the way through then came back to 2 1/2 hole saw to finish spacer ring. Judging from quality of light I would never mount these under water Basically you get what you pay for. All lights work as advertised not the brightest but adequate. Some reviews have reported cracks that I believe come from tithing them down to much during installation. This shows quality of product. I made sure I didn’t tighten them down too much but I really didn’t need a water proof seal where I mounted them. Lights came the color as advertised but after reading reviews I did double check before installation. So far they work fine but only have used them for a month now. I would not buy these lights again because of installation problems.

Over heats really bad

These are very nice 316 LED lights but I use them as a stern light and only need one. I am not dissapointed in having a spare but would have preferred to only purchase what I need. They work extremely well as a stern light on my sailboat. They are the exact format as the incandescent one I replaced so they were a simple remove and replace and they are brighter than the incandescent lights at a lower power draw. I will buy these again if I have the need.

Muy buena luz, pero muuuy grande para la mayoría de las áreas. Quizá esta hecho para yates. El cable es muy corriente y delgado

Great boat replacement lights

Good fit. Nice Colour. Exact replacement for my Grady White

These were an exact fit for my stock lights. One note. Then can Not be hooked up directly to the aluminum wire that feeds the cock pit lights on my Sea Ray. You need to cut off the plug and wire it direct.

Easily installed, perfect replacement for old lights. Looks really nice lit up. The wires are very thin small guage. I hope they are durable and long-lasting!