Magister Hydraulics Double Acting Hydraulic Cylinder - Cross Tube Hydraulic Cylinder 1.5" Bore 4" Stroke - UniversalHydraulic Cylinders (1.5x4)

Ordered these for replacements on my tractor loader. A little large in diameter than I had but worked great! Actually, smoother operation with the new ones. Looks to be really good quality. Time will tell.

I have a low hour mid 80s Kabuto b6200 with a 1640 front end loader. The bucket rams started to leak bad and there is no rebuild kit or replacements online. Found this with the correct measurements. Just needed a few washers for shims at the pins and the hose adapters. I used BEITERSTOE (2-PACK) 6901-06-06-NWO Hydraulic Hose Adapter Fitting 3/8"Male Adjustable Nut O-Ring Boss(9/16"-18UNF)×3/8"Female Swivel(3/8"-18NPSM)90° Elbow SAE Pipe Joints Tube Connector Carbon Steel found here on Amazon. Works great.

Works great. Had to cut down both ends to fit my tractor. Wish they made cylinders with side ports. Oxts an extra $100 for fittings to make them work on a John Deere.

After only a few hours use one of the rams blew a front seal. Leaks badly.

I dropped a tree trunk on the stabilizer cylinder on my Kubota backhoe. The backhoe is 19 yrs old, neither actuating arm (bent ) nor cylinder available. Because of the excellent dimension spec provided by Amazon, I was able to select a replacement by Magister manufacture, and it was an excellent fit (rear pin mount required minimal grinding to accommodate width- about 5 minutes), and I am back in business. A 5-star replacement.

i bought these for my loader and still working no leaks after a year

This was a close replacement for a grapple arm cylinder that was leaking. It was less expensive to buy new than to have the old one repaired. I could not find an exact match (except for length) and had to find fittings, a new pin and some bushings to make it work and it does. No leaks and seems a little more responsive than the original.

Super wide mounting base. What does this fit? I can definitely say its not for my tractor. I may have to rewrite a review if i can weld a different bracket to use it...