Alphacool NexXxos UT60 Full Copper Radiator, 360mm, Triple Fan, Black

The good: Unbeatable performance across the full range of low, mid and high RPM fans. The bad: The paint quality is crap, and the fins are as fragile as snowflakes. If you are clumsy, avoid. Push: I have a 360 and a 480 of this model, the performance is unreal. They keep my 900W TDP system at a 4C delta-t with Noctua F12s in push.

I love the radiator and it has performed fantastic, however i have to knock a star off because one of the stop plugs that came with it leaked and had to be replaced.

Cool radiator, fins are pretty fragile, packaging was great. I did notice that the outside shroud was a little more boxy than I had anticipated. There have been some reports of poor paint jobs, but mine seems to be as expected. It's a nice, thick radiator for a decent price from an Amazon vendor that's prime eligible.

I own 2 other 120x60's sold by TITAN RIG and love them to death for my 14900k, OC'd Now that I have this trippple, the other 129's will be for the video card 😈

For the price of a car radiator, this radiator should be well packed and the fins should be flawless on arrival. Mine went through the fedex ringer but shouldn’t be a problem. If they had included any sort of packing foam between the shipping box and product box, then I would probably be leaving a 5/5. Sorry, but it’s going back. I can’t have a radiator that will not pass a leak down test float above an$$$ ton worth of electronics. Purchased from the seller that starts with ModMy

I have two of these mounted in an Enthoo Primo case and they fit PERFECTLY... specifically the bottom one. Literally fits within less than a millimeter of clearance. The top of the primo case can comfortably hold a 480 if you want to go a bit larger though. I have some cables stuffed up in the top of the optical bay area so I went with a 360 up top. BE SURE to flush this radiator if you buy one. Alphacool are notorious for leaving some flux/debris behind in their radiators. Neither of mine had very much but was still enough that I was glad I flushed before final fill.

Have it mounted on the bottom of my Phanteks enthoo 719 build. As you can see it’s a thicc boi. I’m rocking 3 rads, one 60mm thick , one 45mm thick, and a slim 25 mm rad. My cpu is a Ryzen 9 3900XT OC to 4.3 GHz all cores & undervolted to 1.28 Mvz, and with these 3 rads it idles at around 40C and under gaming load about 55C. Cinebench stresses it a bit more and it jumps to about 60-65 C. Would a less thick rad on the bottom make a difference ? Probably not. One thing I will add is that Alphacool does not coat the fins on the rad black for some reason, so you can see the exposed copper, so I’ll knock off a star for that.

Does exactly what I had hoped it would do. Running this on two 290x video cards. Temps never go over 45c