Hitch LED Light, EBESTauto 4 Inch Tow with 2 Inch Towing Hitch Mount Brackets Bar for Truck Trailer SUV Pickup Fit Dual Led Off-Road Driving Light bar

The wiring on the lights could be a bit longer so you can tuck the connection up under the bumper or have that out of sight. The holes also had to be drilled out for the bolts to go in. Other than that easy to install. For the other customers, I used the 12v power off my torpedo plug and ran a wire into the cab for a switch and then also wired a flat plug on to disconnect it at the back from the switch for removal. The bracket is pretty narrow so I could see the lights being in the way of safety chains. These are pretty right lights!

Great auxiliary lighting setup, the typical LED fog lights have a fair amount of brightness for first few hundred feet, 100-300 feet then light seems to dissipate past that. I have a towing receiver on the front of my truck and was going to mount this on the receiver but it was too close to the top part of the bumper cover so I used old holes from the stock fog lights to mount these which worked well. Fair amount of adjustability to hold them in place and point at the ground and not blind other oncoming traffic. For the $ you cant beat these. Most will use them as hitch mounted auxiliary reverse lights which they will work great for as long as they do not inhibit the use of your trailers safety chain loops. I would give them 5 stars, Now hopefully they will hold up for more than 10-15 years and earn that 5 star rating for longevity as well as performance. Good luck with your lighting projects and hope this review has helped you with your decisions.

Does NOT fit 2inch hitch. DO NOT BUY! Too small of opening. You have to grind the cheap metal it’s made of. Don’t waste your time. Above is the REAL 2 inch below is the crap I bought from these guys.

I bought these for my '07 Tahoe. Pretty nice product for the money. The mounting bracket is actually pretty nice. But as many others have stated, it will not fit without some fabrication. Even if it did, it's blocking the safety chain ports and trailer wire harness socket. SO I wound up chucking the bracket into my spare parts bin and just mounted the lights right to my existing bumper brackets and actually worked out great. VERY bright. And very good looking lights. I have them setup on switched power so I can turn them on at will. I may get another set to mount on my boat.

So I installed these on my 2005 Avalanche. Installation was easy. Absolutely no installation instructions were included in the packaging but a picture in the description dad the wiring diagram. Other than that it’s pretty much common sense. I need these because the back up lights on my truck were not bright enough. These worked perfectly. Very bright. I connected the positive wire to my back up wire in my trailer connection and grounded the black wire to the chassis. I wired it this way because I didn’t want have to have to flip a switch every time I backed up. I rather have them come and off automatically.

The lights themselves are nice, but the bracket is poorly described. When advertising it fits a 2” hitch, one would expect that it was engineered to fit on a the outside of typical 2” receiver as the illustrations show. It is not, it’s engineered to fit on something smaller and has a 2” center hole, which in hindsight is noted on a very small image in the illustrations. I ended up just mounting the lights to my bumper, which probably ended up working better and looking nicer anyway. No chance of interference with using the hitch or safety chains with the lights mounted to the bumper.

They are great! I installed on my 2019 Chevy Silverado. I spliced into my back 7 pin tow wire for the reverse/cargo wire. (Green/white stripe) and when I reverse they turn on. Full glory!

Like product but needs to com with clearer instructions