RANSOTO Engine Oil Cooler And Oil Filter Housing Compatible with 2011 2012 2013 Chrysler 200 300, Dodge Charger, Grand Cherokee 3.6L Adapter Assembly | 5184304AE, 5184294AC

This oil cooler filter housing adapter is a solid replacement for my Jeep Grand Cherokee. It was easy to install, and it’s been working flawlessly since. The engine runs much smoother, and I haven’t had any issues. Great product and excellent value for the price. Highly recommend!

i am saved by amazon again this part is strong i just installed it, no warning lights every thing is fine no leaks i tried fixing the old one changing the seals and it failed every time first time by a so be mechanic it was terrible to see all the coolant leak out in 5 minutes of driving. im lucky my friend hector a mechanics , told me that he was sure that the oil cooler was the problem i was concerned that the part from amazon would not work so happy i took the risk i'm back on the road don't hesitate buy this part it will fix your problem. so happy i worked on it myself it would have cost me a fortune to get fix at the shop. i love my caravan so happy its fixed.

The engine oil cooler assembly was not easy to access because it's located underneath the lower intake manifold. Once everything is out of the way, the part replacement is relatively easy. Just have to make sure to use the vehicle manufacter's torque specs and sequence to install the oil cooler properly!

Lasted 5 months before it failed and started leaking everywhere.

Worked ok but oil filter is different from original gonna have to charge part number for filter in future oil change

Works good! Had it on for several months now no issues. Took advice of a previous review and got the mahle gasket kit. No leaks no problems! Little time consuming to change but this was my 2nd time with the intake off. Worth the money!

This part does not fit as described. It should fit the same as the original part but it does not. The oil tube into the engine is too large in diameter and as other purchasers had explained regarding sanding the tube, I had to do the same thing. Also, the coolant nozzle end on the back side of the part is too round for the rubber hose and the clamp to go over the nozzle. I had to sand the nozzle end as well because there is no clearance between the hose clamp, once installed on the hose, and the oil pressure sensor. These are all huge design flaws and should fit exactly as the original part being replaced. I was in a pinch for time and modified it myself and hope it holds up.

Installed on 2012 Jeep Wrangler about a month ago. No problems so far. It is identical to the factory part it replaced. Oil filter and both sensors were included.