Barrina LED Linear Light with Remote Control, 4ft 45W, (Pack of 4)

The media could not be loaded. Amazing lights. Bought a total of 12 with 4 corners for my garage. Takes awhile to install perfectly and then pair all 16 pieces with the remote. But so worth it and great great quality!!Pictures and video are halfway through installation. Still need to cut the excess hang wire and install a few more light covers. Great product though

I've debated on making an affiliate link for these lights because everyone that comes into the office loves the look and function of these lights and asks me where they can buy them.They look great and are easy to use.Not sure if the electrician lost the instructions or if there just weren't any, but I did have to go into the amazon questions to figure out how to pair 3 sets of lights to 1 remote. So for future people reading reviews...HOW TO PAIR THE LIGHTS:You can set up different combinations of lights to the A, B, and C buttons on the remote, or you can combine multiple sets of lights to 1 remote by doing this. 1. Turn off the lights that you want to link. 2. On the remote hold down the A, B, or C button until you see the red light flash. 3. While hold down the button turn on the lights that you want connected. That should do it.

The product and options for lumens and dimming ability make this a fantastic light that is attractive, sleek and versatile. While installing these lights I dropped one of the threaded hangers, it disappeared never to be found again, I think it went down the floor drain of the utility sink. I contacted the seller to purchase a replacement. I was disappointed to find out they do not sell replacement hardware. After a few messages explaining what happened and the situation I was in they offered to send me a replacement. I was excited to hear that it would be free of charge. Come to find out they didn’t send a replacement hanger, they sent a whole new light. WOW!!! They could have disregarded my situation as my fault, instead they went above and beyond to help me out. Thank you!!!

These lights look great and are super bright. The color adjustments are great to match lighting you currently have already. I wish there was a remote holder for the wall next to the switch. Installation was straight forward, but the wall anchors the kit comes with are horrible(the material on them are too soft and hard to hammer in correctly unless the pilot hole is the same size.) I had to use ones I already had. Overall, I'm really happy with these!!

We've had a horrible experience with these lights since we purchased and had them installed. They came with like 4 remotes, none of which worked for all of our lights. Then some remotes didn't work so they sent us more remotes. We now have 8 remotes and only 2 now work.The worst part however is how the lights constantly change colors whenever they are turned off and then on again. Which means our store now has ceiling lights of all different color temperatures. Which we can't change because the remotes don't work.

I found these while searching for lighting to use for my 9' A.E. Schmidt Regal table.After a search produced a Predator Arena Light, nothing other than a perimeter lighting solution was going to be acceptable. However, there was no way I could afford the Predator. Even these Barrina lights were a lot more than I had budgeted, but I'm extremely happy with the results.I used some baseboard molding to build a frame to hang the lights from. There is a hole at each corner (and through the ceiling) to allow future adjustments to the height of the lights if desired. I have them hanging 16 inches from the ceiling to reduce "cue collisions". At 21,000 lumens (6 x 3,500 lumens each), I only use the 3rd or 4th lowest brightness.I did have to wire these through a switch due to the fact that a power outage renders the remote useless until they are synced again.The remaining two lights were used to illuminate my dart board. I hung them vertically from the ceiling about 3 feet from the board and 4 feet apart.Yes, this took a *lot* of time to design, build, wire, and install, but I have more time than I do money.Please note that these lights are *not* black, but a very dark grey, which I liked much better.

Aesthetically the lights look nice. However there are too many downsides. The colors switch when flicking your switch. You cannot lock in a color. They are advertised as dimmable but they cannot be used with a switch dimmer only their remote. Using a switch dimmer makes them flicker and the breaker buzz. I will attempt to return them.

HOW TO PAIR THE LIGHTS:You can set up different combinations of lights to the A, B, and C buttons on the remote, or you can combine multiple sets of lights to 1 remote doing this:1. Turn off the lights that you want to link.2. On the remote hold down the A, B, or C button until you see the red light flash.3. While continuing to hold down the button turn on the lights that you want connected.They should now work in harmony.

Sleek and bright