Flat Mask Nose Aluminum Wire, Adhesive 50 Pcs 90mm Strip Bridge Clip for Face DIY Making Accessories Crafts

These nose pieces are not sturdy enough for use on a reusable face mask. 8 bends and they break. They are not thick enough to be used for this purpose. So, now I have to search for another source! Not a happy customer this morning......... :(

I’m going to write a review that answers the questions I had. Just got these in the mail. They are a great size, and they have rounded edges so won’t fray/catch on fabric.The adhesive seems strong but it is removable. I was wondering about this because I’m planning to use on fabric face masks that I will be washing. I was able to iron on the wire to a piece of fabric (highest heat, with another piece on top of it). Once it cooled down, it stuck pretty well and bent fine, but I could also peel it off of the fabric with no ripping. Once it’s peeled off, it can’t be reapplied though. It did leave a slight residue on the fabric, but nothing major.I bent it back and forth a bunch and it didn’t break in half but it did warp a bit. But for regular mask use where you’re bending a straightening only a few times/once per wear, it would be great.I think it will iron these on to the outside of my pleated fabric mask, and then peel off and replace as needed. Or slide into a sewn pocket for them and just try not to bend it too often. I will not put this in the dryer.Very pleased with this purchase. It will be better than the pipe cleaners I was using.

The seller more than made up for the lateness in a little extra product. I might even make use of them. I use these to create a mask that is closer to the N95 masks used in hospitals, but because they use a HEPA filter they fog up glasses. With the nose wire, it is much better, and much safer for all concerned! They work great, the sticky is nice, but I did sew it into a pocket. They are also easily washable, but I would recommend and lingerie bag. Several of the nose wires were pretty bent, but easily flattened until used.

Certainly didn't need 50 of these but that was smallest amount available. Have used them for nose pieces in face masks - sewing them into the middle of the top of the mask. They seem to work fine. Easily bendable to fit contour for each person. Have no idea if they'll continue to bend easily or break eventually, but at the moment they're fine and do make the masks fit better.

Just what I needed to add to my Face Masks I purchased from a friend who made them. I needed them because I wear glasses, and they would fog up because mask was away from face. These were able to fix the problem. They do end up breaking after repeated bending and flattening. So I’m trying not to do that as often as I was. You can replace by heating it back up. They are great!

I have several custom masks that do not have nose bridge clips to allow adjustment at the nose. These strips were advertised be adhesive to enable to just stick to the mask. Wrong, there were no adhesive material on the strips. I had a suggestion to iron them on, well wrong again. I tried several strips at different heat settings without success, I did succeed in ruining my favorite mask. I could not think of anyway to repurpose the strips therefore, I just threw them in the trash.

These little nose pieces are uber-comfy once installed but the lighter technique is a joke. I put a light coating of Gem Tack on the backing and then used my iron at a LOW setting. Let the tacking fully dry for about an hour. Seems to hold well. I’m going to hand wash my Mask and air dry, just to make sure the nose piece doesn’t dislodge.

I am making face masks for my family, and these are great. I have sewn all around them to make them stable in the mask. Then bend easily to fit your nose, and they bend easily back to the original shape. Great service by the seller for getting them to me in a timely manner. Thanks