VEVOR Arbor Press, 0.5 Ton Manual Arbor Press, 4.6" Maximum Height, Cast Iron Heavy-duty Manual Desktop Arbor Press, Precision Hand Press for Stamping, Bending, Stretching, Forming

Great press for the price !!Did a great job for my needs and was packaged wellOthers on here mentioned surface rust, But this came clean and well oiled and coated with a lite greaseVery good in my opinion !!!Would recommend this product

Received the product and first thing I noticed is how beat up it looks. Scratches and wear and tear damage everywhere. The product had black paint coming off onto my fingers and ruined my carpet. The base where the metal plate is had some grease/oil from whoever used it before. The packet with the screws had dirt all over it and was cut open from the bottom. Overall very dirty and disappointed in receiving a used product.

It works very well and is easy to use.

I'm no machinist, but I do like black walnuts. Bought this "used" because it's about half the cost of a dedicated walnut cracker (of dubious/unproven functionality). It arrived covered in an oily coat of nastiness (think dipped in a vat of used motor oil) that no doubt protected it in its long voyage through salty air, from China. It was well-packaged in a sturdy box made of 1/4" plywood and cardboard. It proved to give more than enough force to crack walnuts, but I'll have to figure out: (1) a way to steady the nuts under the ram, (2) just how much force to apply without totally pulverizing them, and (3) design a sort of table of 3/4" plywood with a rim around it that I can bolt to a steady base (like a big block of firewood). This should replace the tedious "hammer and rock" method (that sometimes endangers fingers) of cracking walnuts for years to come! I may even find other uses for it as well. Probably would buy again.

A Good tool, and ram tool hole is useful. The throat height would be more useful if teller.