10pairs 24AWG JST ZH1.5mm 2PIN Micro Electrical Male and Female Connector Plug with 150mm Wire Cables

Great wire connectors, I got them for rc car wiring as it seems like they use 50 different kinds of connectors in them, so I had to get a bunch of different sizes.

These JST ZH1.5mm connectors provide reliable connections for small electronics projects. The 24AWG wire gauge is appropriate for the connector rating, and the crimping quality is consistent across all pairs. The 150mm wire length offers good flexibility for various project layouts while remaining manageable.The pin alignment and insertion force are spot-on - connectors mate securely with a positive click but don't require excessive force to separate. The polarity markers are clearly visible, helping prevent incorrect connections. Wire stripping is clean with no exposed strands that could cause shorts.Build quality exceeds expectations for the price point - the plastic housings are properly molded with no flash or rough edges that could interfere with insertion. The strain relief on both male and female connectors is adequately implemented, though adding a small dab of hot glue for high-movement applications is recommended.One consideration is that the wire insulation could be slightly thicker for better durability in tight-bend scenarios. The 10-pair quantity provides good value for prototyping or small production runs. For makers and electronics enthusiasts needing reliable micro-connectors for low-power applications, these offer a good balance of quality and affordability.​​​​​​​​​​​​​​​​

The kind of reliable parts that we needed. Size as perfect. We got thesm because we're developing a product at our house that we hope to manufacture. Not only would buy again, but we WILL buy again when we go into production. It's just at our kitchen table, but its fun. -- Luxine / Miss Understands

Couldn’t find a good pin kit for this type of cable and only needed one, but I guess it’s nice to have way too many spares lol. Works great, no issues, decent quality.

I was hoping these were the right plugs to wire lights to the ESC, but they're not. I used them to extend the factory wires instead.

I used 3 of these to connect upgraded fans to my Neptune 4 Max 3D print head. These worked perfectly with my printer. I cut them to length and soldered them directly to the fans. I had to swap pins on 2 of the connectors to match the polarity of the print head. They pins came out and reinserted without issue.

These were perfect for my application which needed these connectors on short leads.

The wires are a bit thin, other than that everything is as described and worked well.