40mm Heat Sink Kit 40 x 40 x 11mm/ 1.57" x 1.57" x 0.43" Aluminum Heatsink Radiator Cooler with Thermal Conductive Adhesive Tape Cooling Fins for Peltier Module Computer PCB Charger Electronic Router

Saw a few ROG Ally videos and came across this mod for the SSD. This heatsink does work and it did improve the FPS; however, if you are using this heatsink for the SSD, you will need to file down a corner near the GPU heat pipe to avoid damages to it during reassembly.

I got them because my ASUS motherboard Southbridge gets SO HOT. These stick nicely to a clean surface (another flat heatsink) and I've even got a tiny 30MM fan screwed to it.Brings the temp down ~15 degrees.

Chromecast was overheating, smacked one of these on both sides, and problem went away immediately!

These work great on my Ender 3 BUT I had to cut 4 rows of fins out to make my Y axis bed move correctly as it would get caught and stop. I think this is due to me using the metal bed screws instead of the stock black plastic ones. So if you have a stock Ender 3 with the stock bed screws then I think this would work with out any modifications.

El producto llegó temprano y funcionó bastante bien,mejoro mi impresora

I needed a way to cool an excessively hot charger that I have. I tried this and Bam! The charger runs much cooler now. Amazingly simple.

They work fantastic, I used them on the back of my steamdeck with the jsaux backplate and they dissipate the heat well without getting so hot they burn your fingers. The tape is also very sticky so once you put them somewhere they ain’t coming back off.

The look of these heatsinks is great and I think they would work great if the adhesive they used was any good. I prepped the metal surface with alcohol wipes but could not get the heatsyncs to stick.