Eytool Car Door Protectors Edge Guards,16Ft(5M) Car Edge Trim Rubber Seal Protector with U Shape Car Protection Door Edge Guard Fit for Most Car(Black)

Very easy to install and the results are excellent... good looking and protective.

I got this to try to protect the door edges of my new Model Y, as my garage is pretty cramped. I was concerned about how well it would adhere due to other reviews, but I took a chance since it's cheap. I also decided on this over door edge paint protection film since it is easier to apply and a lot thicker. Surprisingly, it's been several days and the edge guards are still perfectly adhered. Granted, I haven't driven much yet, but it's already an improvement over those who said it fell right off. I was pretty careful about the application, though. This was my process: 1. With the film still on the adhesive, I fit the guard to the door and cut to length. Don't try to cut the guard directly on your door or you'll damage the paint! 2. Not having isopropyl, I cleaned the door edge with Invisible Glass and paper towels, inside and out, making sure it was dry afterward. 3. I peeled off a short length of the protective film covering the adhesive foam and started fitting it back on the door from top to bottom, slowly pulling the film away as I went. THE ADHESIVE GOES ON THE INSIDE OF THE DOOR! The adhesion wasn't super strong at first, so I had to hold the adhered portion with one hand while fitting a new section onto the door. 4. While fitting, I made sure to pinch the door guard onto the door's front and back while also pressing it onto the edge -- if you just press onto the door edge parallel to the surface of the door, the adhesive won't stick well. 5. Since my garage was cold (~40F), I then took a hairdryer on high temperature but low airflow and warmed the edge guard in sections ~4" long. I counted to ten before moving to heating the next section. While the next section heated, I would then use my other hand to again pinch the front and back of the door guard together to make sure the adhesive was stuck fast. I worked slowly like this from top to bottom. 6. I repeated all of these steps on the next door. The Model Y front door edges are almost completely straight, but the back doors have a pretty sharp bend to go around the wheel wells. The edge guards buckled slightly at this location, but they are rubbery enough to not leave a gap. The white color is somewhat whiter than Tesla's white paint, but it doesn't look off-putting. I chose white rather than clear so that any dirt that may collect inside the guards won't show through. It has yet to be seen how durable these are in the long run, particularly in the rain or after extended UV exposure. I'll update the review if I notice any problems. Also, for what it's worth, the protective film on the adhesive foam layer was printed with the 3M logo. I hadn't seen any mention of that in the listing or other reviews, so it gave me a bit more confidence in the product.

This product is inexpensive and I think reviews should take that into account and not expect it to perform like higher priced products (Husky door guards are $150!). It installed easily and seems to be staying in place for now. I would expect it will provide some protection from minor door dings. It is still clear will update if it yellows like some other reviews mention.

I got a door-edge protector for my car, and though the quality seemed good and I installed it properly, after a car wash and rain, moisture got trapped inside, causing condensation. This will lead to rust over time. I strongly advise against this product: its design allows moisture in because the adhesive is only on one side. Over time, corrosion will occur. Instead, use a film that adheres fully. The seller was great, but it’s just a design flaw.

Great fit on my 2015 Mustang GT. Went around sharp bends in the door easily. Seems to hold well. Make sure you put the gray glue on the inside of the door which means you have to swap ends from one door to the other. Looks great. Will see how well it stays in place in the long run. So far so good.

More difficult to apply than I expected. I installed it on all 4 doors. The rear doors have more bends required. One door did not hold. The bend were not smooth. The plastic is not very pliable. On one of the rear doors the trim came loose. It did not stay put. Even after several tries. Too late to return. I upgraded to a White Rubber edge guard. Goes on easily and seems much more secure. I would avoids this edge trim, unless you have a long straight edge.

Excellent product! Easy to install and invisibly clear once it is.

easy to apply! really useful. I will buy again

Absolute garbage, came all twisted and kinked and it doesn’t straighten up, also the sticker doesn’t work at all, complete waste of money

Very easy to install, protects edge of the door from bumps.

Protege muy bien el borde de las puertas del coche

Molto facili da installare e soprattutto non si staccano col tempo. La colla non è mai colata, nonostante un paio di estati caldissime e la gomma non si è ingiallita. Ottimo prodotto

Useless plastic strip. Came off flying in first ride only. Was left on one door only & GATHERED dust very fast.