Ogrmar Plastic Dustproof IP65 Junction Box DIY Case Enclosure 11x7.5x5.1 | Plastic Junction Box with Surface Mount Design, Durable Housing, Easy Installation for Electrical Wire & Cable Protection

Very stout and well made box. Feels very high quality --- you'll believe it could survive a typical "garage" impact without difficulty. Worked great for my installation of a level 2 EV charger in my garage. Worth every penny.

Very nice project box at good price.

Shipping was very fast. Price was very reasonable. Well made. Will use this project box to make a portable power supply. No complaints.

This is a nice PVC box and will work well for consolidating my two solar strings before entering the disconnect switch. My only issue is the plastic cover screws, they may be the weak point. Avoid over tightening them and should last a long time. There are no KOs, so placement should be easy with a Uni-Bit step drill.

Edit 04.27.2020: Thickness is ~1/8". I mis-calculated it when I originally wrote this review. Now corrected (below).I purchased the 7.8" x 4.7" x 3" box with flanges.I have to say this is a decent project box. It is plastic, and is significantly thicker than the typical project boxes you'll find at stores such as Radio Shack and Fry's. The box feels sturdy, and my impression is indeed it is. I would say the plastic is approximately 1/8" thick. I know because I've cut several holes in this box.One thing worth mentioning in more detail is the lid. First, the weatherstripping must be manually applied, as others have mentioned in their reviews. Second, the lid is taller than I expected. I believe the height varies depending on which size box you order. This box is about 1 inch or so. Perhaps slightly higher (I have it screwed together atm and not near me or I'd measure it). The lid is also the same material thickness.When you put it together, you could probably hit it fairly hard with a hammer and I would expect the box to survive the blow. Now, that's within reason of course, but the point is it is about as sturdy as one could expect for a $15 plastic box.

Good quality. Shipped fast.

The build quality seems good and I liked the design allowance for the 6 screw holes that are completely isolated from the box built so there won't be any water leak into the box from the screw holes. It does not come with any openings on the box which was my preference as I had odd sizes to drill. I had to drill three openings with a hole drill bit and the cuts were nice with no shattering or cracks as a result which I have seen some people complain on some other boxes. It also comes with a water tight rubber sealant to secure the lid to the box. I am satisfied with the box and its quality as a whole, the price seems a bit too much for a simple box.

Nice sturdy box . Used it on the surface grinder in the shop. Mounted right to frame, small enough to not get in the way.

Good enclosure

Wonderful !

Product was as described.