Corsair Dual SSD Mounting Bracket 3.5" CSSD-BRKT2

Product Quality and Fittings are Good. and weight is Less.

Outstanding quality and superb fit and finish as expected from corsair. You can use it to mount two SSDs in a single desktop HDD bay. Please keep in mind IF YOU HAVE L-TYPE PSU SATA POWER CONNECTOR THEN YOU CAN NOT POWER TWO SSDs since they will interfere. So you have to buy a extension SATA cable for the same purpose. The gap between two ssds are just fine and It holds properly with screw. Installation is a breeze. So you you have any specific requirement like mine it is totally recommended but otherwise it is costly product to buy if quality is not that important to you.

The holes for tightening of screws align perfectly and being a Corsair product the quality is very good. The packaging was adequate for the product. Delivery took about 6-7 days, so if you are going to buy it, then i would suggest not to go for the fast delivery as it would cost more. And one more thing you will get all the screws for mounting two ssds and securing the bracket to the cabinet, so dont need to worry about the screws.

This is a well built item, feels solid, and can hold two 2.5" drives. It comes with mounting screws for your drives as well. For this part of the review, imagine the drive you want to mount is sitting on a table horizontally in front of you, one of the broad sides down on the table. If you look at the area where you connect cables, you will notice that connector is either on top (facing upward), or on the bottom (facing downward). It is important to note that the mounted orientation of drives in this bracket is with the pins facing downward in the bracket (otherwise the screws can't align through the bracket into the drive). The main way this can be a challenge is if your power/data cables come into the drive mounting area from above, you may have to put additional stress on your wires bending them to fit, attempt to re-route them through your case so they come in from underneath, or you may have to use a different wire set designed to come in from below. I wish there was a way to allow a more universal mount, so purchasers can mount their drives in the bracket with the pin orientation either (or both) up/up, down/down, or one up/one down. But in the end this bracket does what I needed it to do, which is to mount an SSD in my computer and provides room for an additional drive in the future, if needed. It works as designed, and not everyone will encounter this challenge...so it gets a 5-star from me.

It is a perfect mount for 2 SSDs. Both Samsung 860 and 850 SSDs were easy to mount and the enclosed screws matched the threads perfectly. There is sufficient room for the connectors and air flow. Definitely use a magnetized screwdriver to screw into the SSD through the bracket. With respect to mounting this bracket, within individual PC cases, your mileage may vary. Worked fine with the bottom holes aligning with the Antec trays on my PC. Delivery absolutely unreliable, because of the postal strike. Wish Amazon gave a choice for other non-postal options.

DELLのスリムデスクトップにSATAのSSDを増設するために購入。 問題無く取り付けできました。 PCの方、DELLじゃなくてマウスとかでもうちょい自由度の高いやつ買えばよかったと後悔してます。

I was pleased with the SSD Mounting Bracket, it did the job which is the most important part. Before I purchased it I requested information from the seller several times... crickets, no response at all. But I did order it and it did eventually arrive, it was a nervous wait.

As you would expect from Corsair, this is a quality product. I was able to quickly and easily mount two SSDs in my desktop PC; one existing one that I swapped out of a single mounting bracket and a new SSD to replace it as my main drive. I've not had any problems since. I would definitely buy this again.