10 Pairs 1.25 mm JST 2 Pin Micro Electrical Male and Female Connector Plug with 80mm Wire Cables

These connectors are definitely not waterproof. But I needed a way to add a small switch on my handlebar and run the wire for the switch inside the handlebar and then down the spine of the bike to a component hidden under the seat. The only problem was that I needed to be able to connect the switch to the wire after the wire was in place and I didn't want to solder and heat shrink so close to the chrome handlebars. The wire is carrying 0.8mv to provide a momentary contact so I am not worried about shorts or water. This worked well. The little connector is barely larger than the wire and once connected I put conformal coating on the connector where the red/black wires attach and then a wrap of electrical tape before tucking it inside the handlebar core. I can easily remove the tape and replace the switch or relocate the switch with ease.

Makes for a quick hook up and take down on my Christmas village.

Thus far, I am happy with the 10-pack of these connectors. Despite being tiny and a bit difficult to work with, I needed something very small. I recently bought an off-brand doorbell camera, and after a couple months it went dark, saying to replace the batteries. I found it contained what looks like a 3.7 volt RC cell, which I think can be recharged. I bought these connectors to assemble a removable charging circuit for periodic use. Even with a magnifying glass it was hard to see how the male & female joined, but I finally got two pairs together and used an old volt/ohmmeter to test. And by gosh, continuity was good, and my project can continue.

Exactly as ordered, nothing missing. Seems good quality, solid wire. Was disappointed that they weren't separated. Not the worst, but would've been appreciated.

Well made from this company

These are VERY SMALL, I ordered them to hook up some aftermarket stuff in my truck. they would be more suited inside an electronic device. I mean tiny small. Super cool parts but not what i need to carry even a few a amps. It was my fault for ordering them but in the electrical parts box they go. will def be used at some point.

I, too, was at fault for not paying close enough attention to the size specifications. These 1.25 mm JST 2-pin connectors turned out to be much smaller than I anticipated—far too small for my intended project. While they did connect properly and appeared to function as described, they felt somewhat flimsy, and the wire gauge was too thin for my needs. Ultimately, I decided to return them. Still, they may be perfectly suitable for delicate or low-power applications.

Used to connect a RAK meshtatstic board. Worked well in my application

It’s delivered at the same date and in good shape