KBS Coatings 4502 Satin Black RustSeal - 1 Gallon

I bought the black Rust Seal for my snowblower and used Por 15 for the orange part. This product is much better than Por 15 - the next day is was hard and I could sand it and apply a second coat. It is a true moisture cure urethane. 2 days later and I can’t touch the orange. Nice product

I bought a 2011 truck recently that had spent enough time in salt that it needed to be taken care of. I sand blasted the frame and a friend at work had recommended KBS. I have never used a product like this. It's almost like it forms a hard shell over the metal, not like just painting it. It came out wonderful and would recommend it to anyone. I am now going to order more and continue up the frame. Word to the wise, use it out of a different container. If you get KBS on the lid of the container, it will not open again. Yes, I made that mistake but this is a minor issue compared to the quality finish you get with this product.

I used this on my saltwater trolling motor. I cleaned all the rust before using this product and the rust is gone. I found that you need to apply very light coats and topcoat it with a UV resistant paint. I used a white Bed liner type spray and love the results.

Works good and gives a hard durable surface. Used this on a car trailer frame. I like that it can be brush applied. Bought disposal brushes and mixing cups off Amazon to work out of when painting, then just pitched them when done. Pour out only what you can use in about 10-15 minutes (depends on humidity and temp). Be sure to seal the can as recommended with plastic to prevent the lid sticking. Gave it 4 stars because the galvanized color shows the brush strokes from being applied. I tried thin and thicker single coats. Thin coats showed the brush strokes much more noticeably. Was better with thicker coats but then there was the occasional run. Also tried 2 coats but results were about the same. Looks good from 10 feet away but not as good up close. Did not have this issue with the black color I used previously. It flowed out nice with no noticeable brush strokes or runs.

1 quart sprayed did 2 coats on small Willys CJ2A Frame. Great coverage.

This seems to be as advertised, it is thicker than regular paint, yet self levels . Use disposable brushes for sure. Key is preparation. Results are based on that. Will have to see after using mower for awhile. This was put on 42 inch mower deck

The one can I have opened so far took a few minutes to open and the top of the can is pretty much destroyed so there is no resealing the can, you either use it all or or you waste it.

Had my doubts about coverage I did not prepare my surface as well as I could have would have taken days. But once applied with a paint brush went on smooth and relatively thick. Covered everything i wanted. Used in on the floor board of an old sports car man is it tuff stuff. Helped my kill mat stick firmly to the car would buy again next time. Excellent value over others worked great.