ワイヤレス介護者ポケットベルモーションセンサーアラートルームベッドアラームと1つのレシーバーと1つのモーションディテクターを備えた在宅高齢者の転倒防止

I write very, very few reviews; but I'm making an exception with this product. It actually works and works great. I highly recommend these simple alarms. I have four of them, all of which are the plug-in kind with batteries for the motion detector. My wife of 56+ years has late-stage Alzheimer's disease. The first one I bought wakes me when my wife gets out of bed. Part of the reasoning for that is she broke her hip a couple years ago and had to have a total hip replacement. I don’t want her to fall again. The receiver (the plug-in part) is connected to a power strip which is fastened to the bed post with a couple of zip ties just above my head. That close to your head, it will just about wake the dead, which I need when I’m asleep. The power strip has a switch with a red light that I can easily turn off to silence the alarm. The red light lets me know it’s on with a glance, even in the dark. The battery operated motion detector (transmitter) is simply sitting on the carpet on her side, underneath the bed. I’ve had it a little over a year and only had to change the batteries one time, just recently. When they need replacing, the alarm sounds and stays on without motion, suggesting something is wrong. When I replaced the batteries it worked again, just like new. Since I bought the first alarm, I’ve purchased them three more times to give me peace of mind when my wife moves about the house. One is sitting on the floor beside the front door to let me know she’s there. They help me keep track of where she is, but by themselves, they're not fail safe. I’ll explain later below… The picture with three receivers plugged into an outlet is in the hall just outside our bedroom door. The left receiver is for the indoor motion detector that sits on the floor just inside the front door. The one on the right is for the motion detector (transmitter) on the back porch. The middle receiver is for the exterior motion detector on the front porch just above the door. Each alarm each has up to 50 different alarm sounds that can be customized to help you distinguish which alarm is sounding. Some tunes are kind of 'cheesy,' but most of them are quite good. I chose a police siren for that one to distinguish it from the other two alarms which have similar, but not the same tunes. I can hear them from most areas in the house. The other two motion detectors are actually mounted to exterior walls: One, above the front door under a covered porch. The other is mounted on the exterior wall above the sliding glass doors on the back porch. Both of them are protected from rain by the porches. if you decide to buy one, you’ll notice that the included directions are not written very clearly. And, they’re written in tiny mice type. I wrote and rewrote them through much trial and error which I included below. I said earlier that these are not fail-safe devices. Because of that and the fact that my wife “escaped” several times before I had our home somewhat “dementia proofed”. I did this by adding another security device inside, near the top of the front door. I finally have some peace and a sense of security. There is also a picture of it on the inside of the front door. It's also from Amazon (see link below), costs less than $15 including tax. It's easily installed; it works great, and my wife cannot understand how to open it. It's simple to open for normal people and would also make a good security device for people in apartments, etc. It can be installed on either a right-hand or a left-hand exterior door that swings inward like ours does in the picture. I think it’s a must have for a loved one with dementia that’s prone to wander or has “sundowners” symptoms that are prevalent with Alzheimer’s. I very highly recommend this product as a potential life saving device. Link for door security device --- https://www.amazon.com/dp/B07DR9CMGZ?ref=ppx_yo2ov_dt_b_product_details&th=1 Pairing the Receiver & Transmitter Plug the receiver into an electrical outlet and set the transmitter on the floor near the outlet pointed away from you so you can easily activate it in step 4 below… 1. Make sure the Motion Detector Transmitter is ON and pointed away from you. (the smaller battery-operated unit) 2. Set the Receiver ringtone by plugging it into an outlet and short pressing the lower button until you find the tune you prefer. Deciding which tune to use is the only hard part... 3. To activate Pairing Mode, Press and HOLD the Receiver Volume (upper button) for 5 seconds until it sounds and the LED's begin flashing. 4. Complete Pairing by waving your hand in front of the motion detector within 5 seconds. 5. When Pairing is successful the unit will activate the new Receiver ringtone whenever motion is detected by the Transmitter. (There is a 5 second delay between activations; but this can be changed to immediate within the Transmitter)

My 85 year old Mother has broken her ankle and does not remember that she can't walk on it. I set this up beside her bed so as soon as she swings her legs over the edge, it alarms and wakes me up. I am able to get to her and get her into a wheelchair to get to the bathroom before she walks herself in and damages her ankle more. It also flashes a light and has a selection of alarm tunes and volume control. My only complaint is that the on/off switch on the sensor does not appear to work, but I just cover it when I want it turned off.

Uma porcaria Não vem padrao de tomada e nem cabos!

Very pleased with this project! Very easy to use! Very sensitive and works great. I use it for an elderly family member who sleep walks. It has solved my problem. I recommend it highly.

very easy to use and perfect!