Balsa Wood Airplane R03 STICK-06 Model Aircraft, 580mm Wingspan Laser Cut Unassembled Flying Model Aircraft to Build, DIY RC Airplane Kit for Adults Beginners (KIT+Motor+ESC+Servos+Covering)

Built it in spite of crappy instructions

The plane flies great. Here’s the rundown: Electronics used: eflite 2500kv 180bl motor, DSMX/DSM2 6 Ch Ultra Micro receiver BL ESC (EFLU4864), 1x 2g digital servo, 300mah 2s lipo. 130g finished weight I had to make lots of adjustments to the design as it was structurally inadequate. All of the balsa was very badly warped, so I had to steam and put everything under something heavy. I added a 2mm full length carbon spar in the wing, carbon fiber tow on the stabilizers, added extra wood along the fuselage, added CA to the ends of the control surfaces, and because this rx has AS3x I had to have the elevator control horn on the bottom. Battery is put in the nose with hook and loop tape and pushed all the way forward. Flies around 1/3-1/2 throttle without issues, plenty of power for aerobatics. Stalls aren’t crazy aggressive. Very fun to fly.

Too small. Difficult to werk on due to size.

Cheezy kit, bad instructions, no print, you have to add your own pieces to strenthen where the wings attach