EVERBRITE 32 Oz. Clear, Protective Coating for Metal (Quart)

Amazing product, have used it on alley windows - doors alley cladding GRP garage doors it definitely works, cleaning the substrate properly a must only use small amount, it goes a long way.

We have powder coated brown fences and gates. We live in South Florida exposed to the salt and extreme heat . Over the past few years we noticed the fence and gate lost there luster . We applied Everbrite and they look like brand new. I was amazed at the results. Cannot be happier !!!

Works great, dries even with no streaks. Applied over a month ago and no sign of tarnishing on my copper cupola, still brite and shiny.

I used this on some barn steel. I wanted to save the rust and make it all look shiny and prevent it from rusting further. The product is easy to work with and it looks great. It has a wet look and and the rust pop.

This is an amazing clear coat I use it keep the copper jewelry i make from tarnishing. It's super easy to use and to clean up I will definitely buy more when I run out.

Waited 8 months to write this review purposely so it could be as accurate as possible. It has been exposed to snow, sleet, rain, hail, subzero temps and 100+ degree in direct sunlight most of the day. Used this to seal the copper on a brand new cupola on my garage. Cleaned copper with acetone to remove any oils rolled on 3 good coats and the copper still looks like the day I did it. Stuff definitely works. Make sure you do it on a calm no wind day or inside your garage if you can move your project inside, stuff gets really sticky as it’s drying and if anything blows onto it it’ll stick. Was worried I wasn’t going to have enough to even do 2 coats but a little bit goes a long way. I still have left over even after the 3 coats on the cupola and also did 3 coats on the flashing around my chimney and that still looks brand new.