WixGear Magnetic Phone Mount, Universal Stick On Dashboard Magnetic Car Mount Holder, for Cell Phones with Fast Swift-snap Technology

Does what it says..... :-))

I love the design of this product and it is the only holder that works in my Jaguar XF. However the adhesion of the product is not as expected and I'm not happy with it. It's also expensive for what it is. I have found the magnet is not strong However it is well built and sturdy. Overall I think on the right surface this is a good product. I'd like suggestions for a different product that would work for my Jaguar XF.

I have an Elgato Streamdeck and wanted to mount it on my full motion rig and this was the idea choice of things to use.It needed to by adjustable and strong for when i pressed the buttons.The adhesion also had to be strong so i could rely on it, knowing my Streamdeck was secure under the full motion of my rig.It came in no time at all, easy to set up, feels great quality and works as intended.Recommended.

A few notes before getting into the review:1) We mounted our metal plates below the centers of our phones, which is where the wireless charging/pay antenna is located.2) As a result, the phone's center of gravity is above the magnetic mount, which caused our phones to spin on the smaller, round mounts.3) I replaced my own small, round mount with WizGear's larger, rectangular mount.4) I will provide links to both the round mounts and the larger mount at the end of this review.Onto the review...We installed this mount on my wife's vehicle to use with her Pixel 3 XL. She needed a little extra clearance and the arm that raises up an inch or so made all the difference for what she needed.Installation is very straight-forward and very simple. From start to finish, it took me about two minutes. The part that took the most time was getting the mount angled and positioned to where she could easily see her phone. If anything, she would have preferred a slightly taller arm. We know WizGear offers a taller arm with a suction mount, but we wanted to stick with adhesive mounts due to the cleaner look and reduced chance of the mount coming loose at any given time. (We've tried the suction mounts before, but we've had them come loose on hot summer days where the interior of the car can reach over 120ºF.)The magnets felt VERY strong on this mount. They are much, MUCH stronger than those of the smaller round mount I had installed in my vehicle before. In fact, I'm almost convinced they're just a bit stronger than the magnets on my recently-installed larger mount (which I replaced the small round mount with).We waited a couple hours to ensure the adhesive had time to set up a bit before putting any load on it. We then went for a drive, intentionally taking a rough road and making a few hard, sharp turns to try to get the phone to spin on the mount. It stayed put, exactly as I had hoped.The only reason I gave this mount four stars rather than five is that the raised arm is shorter than anticipated. The only place we could place this mount on my wife's car was directly above the infotainment screen. Where the metal plate is located on her phone case (just below center), the phone partially obscures part of the infotainment screen. Now, it's not THAT big of a deal since the blocked portion of the screen does not show any crucial information, but it is still a minor inconvenience. If the arm was approximately 2", it would give plenty of room for the phone to completely clear the infotainment screen and offer a clean magnetic mount solution for virtually all phones on all dashboard locations.In summary, this is a fantastic mount for the money and I do highly recommend it. However, I do wish the arm was a bit taller.Here are the links as promised:1) Small, round WizGear mounts: https://smile.amazon.com/gp/product/B0773F8S74/2) Larger, rectangular WizGear mount: https://smile.amazon.com/gp/product/B01MR4AO9D/

Works as intended and comes with additional hardware.

works well - hands free....

Very good. If you are looking for a good magnet style mount, this one is great. I use it to mount my iPhone 17 Air. Pro tip: Place the metal plate in the center.

What an awesome little item! Paired it with a cat shaped finger ring. Magnet is nice and strong. Haven’t driven a lot yet, but so far it’s held very well. Wish I knew about these sooner! So much easier and nicer than normal bulky car chargers. Only thing I don’t like is how I had to stick it to my brand new dash, but my vents are recessed so I went with this option. So impressed I’d do it again tho! Only advice I’d give is don’t put it too high. If I could do it again I’d put it lower than I did as the piece under the magnet (that holds the wire) angles it slightly upwards. No issues yet, and tbh, I’m pretty confident I won’t have any when the time comes. Very happy with this purchase and would highly recommend. FYI I’m using an iPhone 8 + with an otterbox commuter case and finger ring mounted on the back of the case. I did not use the included case magnets.