F6N0.25BK Flexo F6 General Purpose 1/4-inch Braided Cable Sleeve, Black - 20 Feet

I bought this to cover my laptop charger, because my cat used to chew on it and it is was un-aesthetically pleasing to say the least. This sleeve was very easy to put on (took maybe 5min to cover the charger), and it feels pretty thick and sturdy. The cord looks a LOT better now, and this should protect it from any future cat chewing. Will definitely be using it to cover other cords as well. My only regret is that I should've bought more!

Terrific protection of wires/hoses from rodents

This tex-flex roll really cleaned up my engine compartment in my 67 Dart. It can wrap 4-5 wires at a time. Then I took fiber tape and wrapped each end. This is what I'll buy from now on. Great price for a low buck DYI project. Clean, and nice look. Good stuff!

If you like neat too, than you will like this 1/4 inch sleeve to bring together your mouse and keyboard cables or some other small cabling combination. I have the equivalent of about 3 telephone wire sized cables going through the sleeve nicely. I like the clean look I am left with and that the cables stay put even when gently pulled in different directions. I will note however that I am not as excited about the difficulty getting the wires into the sleeve. I'm sure with practice anyone could get pretty efficient at it, but it took some coddling to get it going. It would be nice to have a tool to slide the wires in. All in all, I would buy it again because being neat IS that important :-)

Stuff is awesome! Replaced the old, cracked looms on a motorcycle with this and it looks load better than when it was new! Simple to use, but there is a bit of technique to get the wires in easily. Play with it and find your own best way. It DOES expand a bit. I was concerned that a 1/4" would work, but it worked beautifully!

This has been a lifesaver- for my avian sun lamps. My conures are huge chewers, and this has finally foiled them. Keeps cords protected from busy beaks. Cut to fit convenience , flexible and durable. Good quality.

I used this sleeve to create a custom wiring harness to run auxiliary lights/air horn/USB power socket for my BMW 1200GS using the Hex ezCAN power module. I was able to fit 4 16g and 2 18g wires (total of 6 wires). It was crowded but the flex sleeve expanded well enough to provide 100% coverage. I sealed both ends with heat shrink tubing, giving the appearance of a factory installation. No special tool is necessary... just a little patience. If you ride a motorcycle and add any aftermarket electronics (GPS, heated gear, fuse block, aux LEDs, air horn, USB charging port, radar equipment, etc.) this product will protect your wires and keep every your bike looking neat and tidy. There are other alternatives but the TechFlex F6 makes for a superior finished product.

Works well, I use it a few different things. I bought it for my computer cables but I got the wrong size and is too small. So I used it on my motorcycle and it has worked out very nicely. Looks good and stays put. I haven't used it near the engine so don't know how well it takes heat.

Very easy to use, gives a neat finish and does hide all the cables, flexible and easy to cut.

Muy buen producto. Superó mis expectativas en la manera en que cierra y protege los cables

I used this to stop the internal cables on my mountain bike from rattling. Feed it over the cables and thread it into and along the cable inside the tube. A perfect solution, works great.

Great and works perfect.

major improvement both aesthetically and functionally!