3M 4910 VHB Mounting Tape, Acrylic Foam, Permanent Bonding, Heavy Duty, Clear, 0.5 in x 5 yd, 1 Roll

I use this to tape clips around my door for Christmas and Halloween lights. I have left those clips up for at least 4 years. This tape is fantastic. Definitely water resistant. The red cover part is a bear to get off. You’ve got to get one corner lifted and then you’re good. It’s stretches too. Highly recommend.

Probably the best two sided tape on the planet. This is not very wide, but it sticks better than any other double-sided tape I have ever used

I am converting a closet into a recording booth and using 12 x 12 x 1 foam panels as sound proofing. One set of panels are "mushroom top" and the instructions recommended this product for applying the panels.For ease of use, this took a some time, yet once it was started it was no problem. In order to peel the red backing from the tape itself, using fingernails to peel didn't work. I actually had to find a YouTube video which recommended using the blade of a knife to dig into the red backing to peel away. This was dead on truth and worked. Once I got it started I would cut the excess red backing just enough were there was a tab to grab and peel for my next amount.The actual tape is pretty sticky and works well. A couple of panels I actually applied to the back of the foam and to the wall, and the tape holds up very well. For other pieces of foam I used tacky spray glue and put a backing on the foam, then applied this product to the backing and applied to wall. I found this to be a better technique and the product is holding the panels in place. So the adhesive works well!I have yet to try to remove from wall as I know that if I remove in the wrong manner it will damage the back of the foam on the pieces that does not have backing. This is why I gave 4 stars under this feature.This product has proved successful for the use I need and this amount has proved just enough for my needs. If I needed to reorder, I would use this again.Hope this helps!

Kinda surprised that it's 1/2". I did a search for 3/4" and didn't pay attention to much. All the photos show wilder stuff not what I got. So I'm in a hurry and bought it. I'm going to keep it but I guess you have to really pay attention when you buy something because it may not be what you want. Search for something is awefull by the way, to much stuff I didn't ask for

Worked on my window attachments

This clear tape works great and comes in a variety of widths and thicknesses. Easy to use if you check out a YouTube video on it but a little tricky to start peeling the protective mylar coating if not used before. Tip. Use the tip of an exacto knife to pierce and start the peel and also cut the tape a little longer than needed so you have an end to touch with your fingers that you don't need to use as you do not want to touch it before applying. Also let the bond cure adequately before putting weight on the object being fastened. Very good water proof adhesive. Takes a little work to peel off surfaces with finger nail but comes off clean. Best product for strong, removable, waterproof, removable bonding i have found so far.

Worked well for mounting a cheap LED light strip on the back of my TV. The adhesive it came with was cheap and didn't hold long, but this stuff did the trick! I wish it was sold in a smaller amount, but at least I have plenty left for other uses.Pro tip: if you're using it to mount a light strip, adhere this to the back of the strip, but let it sit and cure for a few hours before attaching to the TV, it'll help it hold better.

I’m inclined to believe this is a knock-off product because it does not hold AT ALL! I tried using it to stick small little fairy light battery cases to glass jars and after ~3-4 hours they *always* come unstuck. The tape can’t even hold something that weighs .5 ounce. Double stick Scotch tape would have done a better job than this “heavy duty” tape. Also, trying to peel the backing off the tape is ridiculously difficult. You basically have to use a straight pin to pry under the backing, then grab it with tweezers to pull it the rest of the way off. I’m hard pressed to think 3M would sell a product like this.

ممتاز، يجب الضغط عليه

Nice product, sticks very well

VHB is really great and I had used this (retail packaging) before, with no complaints - but this industrial pack is really something different1) the rad protecting layer is nearly impossible to peel off and I struggle quite a number of minutes with alot of contact on the glue surface2) when you finally do succeed, the double sided is slightly "worn / less sticky" by the contact of your fingers doing 13) the double sided VHB is very very nearly gel like and elastic - and it easily springs into one lump sticking with each other when you triy to unstick it from your fingers or scissors - causing you to have to throw and restart step 1,2,3 with a new piece.4) after a few 1,2,3 you suceed and can use it - step 45) will contemplate try sucking the red piece off with my mouth but my mouth may get glued together. ./s

This tape seemed to be legit 3m tape and worked great. It was kinda like that gooey sticky stuff that some companies use to hold products into or in packaging as this stuff is very stretchy. But it does hold very well and definitely recommend.I used it to hold up some 3D wall panels on my wall when some Douglas adhesive foam tape failed.

Great adhesiveGreat product