KingsonPistol Sight Pusher Tool, Universal Pistol Sight Pusher Tool for 1911/Glock/Shield/Sig and More – Precision Aluminum Rear Sight Tool for Glock 19, 43

Product works! For the price I was excited. The main rod has limited reach. The handle will spin and push the main metal block towards your sight. When you run out of room, remove the nut if it hasn’t come off and move block up against where you left off and then retighten the nut and continue to turn to finish tightening the rear sight. This worked very well for my Glock 17 Gen 5. Remember when REMOVING sight: Left to Right and to INSTALL a sight: push Right to left. To push from left to right and then need to push right to left, physically take slide out and turn the tool 180 along the side so the pushing block has a right angle on sight when pushing as a consistent force is needed to properly move sights. To clarify the pushing block has a wedge out on one side. Worth the money and time to figure tool out!

If you have a springfield hellcat do not buy this. It will not move your rear sight. The nyelock nut either tightens up and prevents you from tyrning the handle or it loosens up and xomes off. If any other pistols have an extremely snug fit sight this will not work. The slide vise is also very difficult to get lined up properly but doable with patience however the vice block tends to bindon the slide with any real tension which will mar your sight and slide if you are concerned about the finish in the pistol. This could be a really good product if it was upgraded. The only reason I gave a star rating is you have to in order to write a review otherwise it would have been NO STARS!

The price made me nervous, but this was the only sight pusher I could find that said it would work with a Shield. I can wholeheartedly confirm it works for both the Shield and Shield+ front and rear sights. With a vice and a leveraging bar, it was able to overcome the red loctite from an overzealous S&W assembly worker (the set screw had been removed, I didn’t break anything).

All I have to say is, very easy to use if you have common sense. Used it on a 43x HOTH. Didn't even have to take off the 507k to remove stock irons. Tak your time and you will not cause any damage. Great value for the money, function as it should, and cheap and reliable tool I'll use more than once.

Difficult to use. Would not be if you are using it for installing new sights. Also will only work one direction. When you try to push the optic to the left the nut on the adjustment handle falls off.

Did the job, but kind of a pain to set it up properly. Much safer and faster than beating sights in with a hammer and nylon punch. If you only have to do sights once or twice then it's a great buy.

I'm unsure why others gave such bad reviews. For the price this thing works great removing Glock sights. I had mine off in about 20 seconds with this thing. Easy peezy. Works as intended and much cheaper than most others. It doesn't come with instructions but it's pretty easy to figure out.

I was concerned do to the price, that it was not going to work after seeing all the other sight removal/installation tool that were double or triple the cost. Well it did the job flawlessly.