JRL Dirtbike Kick Stand Fits 70/90/110/125/138/140/150/200cc Pitbike

Works good

fit perfect on my apallo x-16 was nice and sturdy

2nd kickstand sent, both horrible build quality. Lightweight hollow pinched aluminum kickstand - What absolute garbage. Parallel mounting points are not straight/ out of tolerance requires aggressive bending if attempting to fit stock mounting points. The paint is subpar and chipping. first kickstand sounded like spray paint can with a rattle inside. Massive waste of time and absolute garbage product. Look at the welding shown in the picture sub par - couldn't take 5 mins to hit with a flap wheel to clean it up. Low quality items need to be removed from amazons platform. Anybody that said this kickstand was great was paid to do so. Stock kickstand on the left - amazon product on the right you can see the quality in metal/welds/paint/geometry and build vs the subpar build on the right. GIANT WASTE OF TIME!

I put this on my dirt bike and it does the job, but it could be a little better made. It was fairly easy to install and holds the bike up fine. For the price it works, just not quite as sturdy as I was hoping.

Kickstand was complete and went on bike easily, though that spring is tough. Works well enough but I can see why someone might have taken off the original. The stand is very straight up-and-down, meaning the bike could roll forward and collapse the stand. It also, when folded, hits the swing arm. This doesn’t seem to be the fault of the product, and I’m only writing it here so others know what to expect.

Bought this for a razor mx650. I did the front and rear suspension, so I needed a taller kickstand. This needed some modifications to work properly. The depth of the “u” where it bolts to the frame needed to be elongated with an angle grinder, and the gap was way too wide. I had to pound it closer together for a tight fit. Overall, it seems solid, but it is NOT a direct bolt on for a razor mx650. Good value for the price, and I may actually order another because I can’t find anything else that works. Just make sure you have some tools to modify it (angle grinder and mallet).

great

Worked perfectly and good quality for the price easy installation and took maybe 3 minutes.

Purchased to replace my worn existing stand on my honda cbr1100.... unfortunately it's not ideal as there is no hole in the stand for the kickstand sensor.... otherwise it fits and is the correct size 310mm to correct the aggressive lean on my bike....so will stop it leaning too much but would have to remove the kickstand sensor...so at the moment I have ordered a replacement stand bracket off another bike (from a online breakers) hopefully with less wear....

Doesn’t fit 2013 pitster pro 90cc very good is super sloppy and pain to get installed.