Magpul MAG002 Win Original Mag Assist (Pack of 3)

A bit tight on some polymer mags because they're thicker than steel, but they work good and worth it.

This work as advertised. were tight enough to install with little effort, with enough friction so they don't slide off. Less than a minute per M1A Mag.Fast shipping, Would buy from again.

Fit perfect for 20 rd m14 mags. Hard to get on, but you know it's not sliding off.

Works perfectly on my m1a

Wanted/needed these to assist in pulling out my magazines from my double stack mag pouches, and for that they work very well. Seem to be made of some nice heavy grade rubber compound and are a bit of a pain to install on the magazines, but if you warm them up just a bit in your hand, then give 'em a good stretch they go on much easier. I hope to get many years of service out of these.

These fit perfectly on my metric FAL magazines. Using Taco pouches I was able to snugly fit my FAL magazines but these assist devices made things perfect as far as getting them out. The 20 round FAL magazines were slick and a bit difficult to access without these. The use of the Magpul Mag Assist just made an already good system perfect. I installed one corner then using thumb pressure got the other corner started. Once they were on a bit I used the corner edge of a wall to push the rubber the rest of the way.

They work well on M1A mags. They’re tight as hell on 762 PMAGs but can work with a hairdryer to loosen them up before they slip them on.

These were to tight to squeeze ove a mag for a Savage Scout rifle. I will try to loosen them up with a heat gun and see if I can get them to slide over the end.