VEVOR Ultrasonic Cleaning Machine 30L 1200W | Commercial Sonic Cleaner, Heated, For Eyeglasses Rings Jewelry, Large Capacity

This cleaner is a beast, I had the smaller cleaner from the bargin tool store and honestly it worked pretty good but this cleaner is in a whole new level. It litterally forms little waves from the constructive interference lol. It is a great size, I have put holley carbs in it and it does great, of course Id still break them down before cleaning and blow them off with compressed air to keep your cleaning solution from getting instantly filthy. It is made of stainless which so far seems plenty tough. It is loud though but its naturally going to be, if it wasnt Id be concerned. Its has good stability and doesnt walk around or do anything weird like that. The drain valve and little screen thing in the bottom of the tank are awesome, I always had to flip my old one and sometimes water got inside and it didnt work quite right after that. It cleans parts very well especially if using the proper cleaning solution. The only con there is and I think they all suffer from this is if you are not carefull when filling it you can get water inside of it by running down the sides, mine still worked after this but it kept setting of the gfci plug until it dried out. When I got mine it was at an excellent price.

This thing's got some power. The first thing I cleaned with it was the throttle body off my 2000 Jeep XJ. I've had the XJ for 26 years, and this is the first time I've cleaned the throttle body. Let's just say it was due. I used Dawn dishwashing liquid and Borax with hot water, and within a minute the water was very dark. I ran two 15 minute cycles and finished with a little light scrubbing with a soft bristled tooth brush. Great results. I have two complaints. It takes quite a while to heat up, so if you're using water make sure it's as hot as you can get it from the tap before you put it in the tank. The other complaint is the drain hose and the plastic barb. The hose is a bit on the thin side for the application, and when hot fluid hits it it gets very soft and tends to kink, and just not flow very well. But these are both minor annoyances. I fully intend to change the barb for a brass barb, along with a much stiffer hose. I really like the basket that comes with it. It's a good size for the kind of stuff I'm likely to clean. Dunno what to say about the small part ball that was included. I'm sure it will work fine with small items, as long as you're throwing them in with larger parts. The tanks pretty big for just small items alone. But I'm sure it would work. I'm not going to say it's loud, but you'll definitely notice it when it's turned on. I've got mine situated in my basement, and it's only really loud when you're close to it. Sitting twenty feet away in a different room it's not a problem. So, the upshot is this - it's well made, has lots of nice features, looks good and works great. Big thumbs up on this one.

I don't usually write reviews but on this product I feel one is warranted. I am a dyi home machinist, metal fabrication, welding, and automobile enthusiast. It seems like I am always trying to clean grease, oil, dirt, rust, or mill scale off of something. I was aware of ultrasonic cleaners but because of bad reviews I have never gotten one. Most of them are generic and don't even have a company name on them. The complaints were all the same. Very slow to heat up, if at all, and didn't clean very well. They all look the same except for Vevor. They put their name proudly displayed. Almost all the reviews on the Vevor were positive so I ordered a 15 liter model. I also ordered some Simple Green Pro HD concentrate mostly because it is supposed to be friendly to aluminum while the regular is not. It also said it could be used in Ultasonic Cleaners. It arrived much sooner that what the projected delivery date given when I placed the order. It was packaged very well and there was no damage. I was in the process of fabricating a project using hot rolled steel flat bar and square tubing. Hot rolled steel needs to have the mill scale removed before it can be tig welded and powder coated. Grinding or blasting it off takes a lot of time and grinding discs are expensive. I gave up using that process when I learned that a good overnight soaking in white vinegar will loosen the mill scale and any rust but you then need to rinse the pieces off in water and a little scrubbing with a Scotch Bright pad. It's a little messy but it works very well. I had my parts soaking in vinegar when the ultrasonic clearer arrived. I was originally going to rinse and scrub them as usual but then I wondered if the cleaner would remove the left over residue so into the cleaner they went with 3 gallons of tap water and 3 cups of the Simple Green. I set the temperature at 55c and the timer at 30 minutes. It actually heated up pretty quickly and a placed an electronic thermometer in to see if it would actually heat up to the set temperature. After a few minutes it not only reached 55c and shut the heater off but it continued to heat to 57c which I verified on the thermometer. After 30 minutes it turned off and I pulled out the parts. I had a big smile on my face because the mill scale and rust were completely gone and the metal was spotless ready for welding after a quick rinse. I went from hours cleaning scale, rust, and oil from metal parts to doing nothing. Welded them up and another bath in the cleaner which removed everything from the welding and then powder coating which turned out flawless. Next up some greasy, oily 30 year old vise grips which I now use as a clamp for welding and grinding. There was so much build up of crud in the adjusting screw I could hardly turn it. Put a couple of other messy pliers in the cleaner also and set for 20 minutes. Times up, took them out they were all spotless and the adjuster on the vise grips turns like it did when they were new. I can't say anything about the unnamed brand of cleaners but the Vevor worked beyond any expectations I had. If you do metal fabrication and are tired of cleaning smaller parts before welding I highly recommend trying this clearer. You can pretty much put anything you want in as a cleaner. On You Tube I saw some guys even use gasoline. I won't be trying that. I also saw one guy who puts the white vinegar in the machine. I'm going to try that next to see if I can reduce an overnight soaking down to just putting the metal in the cleaner with vinegar.

Very attractive functional unit. All stainless steel with a lid and removeable power cord. Push button controls for temperature and time. I got the 15 liter model. Power for heating and cleaning are actually a lilttle higher than spec'd. Heats from 79F tap water to 100F in 23 minutes (can go as high as 176F). There is a ball valve for emptying and an included fitting and hose if you're not near the sink. I was cleaning a brass clock works that was pretty dirty and couldn't get to everything with a Q-tip, and didn't want to disassemble all the way down to individual gear level. I used an ammonia based cleaner concentrate, diluted 7:1. It got it VERY clean. Dimensions are important depending on what you have to clean. The tub is 12.75" x 11.75" x 5" deep to the fill line, or 6" to the brim. The parts basket is 10.5" x 9.5" Outer dimensions are 14" x 13" x 11" with recessed handles. It weighs about 19 lb. Still don't know where I'm going to store it. The only issue I had was the stated (15 liters) vs actual capacity. It actually measured 11 L to the fill line and 13 to the brim. Quite happy with it!

I purchased this Ultrasonic Cleaner (or should I say, *my hubby* purchased it) on the 17th of February of 2026. It came with what looked like a spherical tea-brewing wire-mesh basket, intended for holding small jewelry, but unbeknownst to either of us, it was also supposed to be shipped with a larger basket that could hold larger jewelry, such as bracelets, etc., which was not in the package. It arrived on the 20th of February, and all seemed well, other than the missing larger basket, a fact we weren't yet aware of. We did not use the cleaner every day, perhaps once a week, on jewelry that we regularly wore. It seemed to perform well, heating up to the target temperature that was displayed on the LED numerical display, and buzzing away, with the typical sound of an ultrasonic transducer getting to work, and using cavitation to clean our jewelry - until the 10th of April. On that day, something caught my attention; the water, despite being dialed in at an operating temperature of 55 Celsius (about 130 F), was cold. I power cycled the unit, and re-set the temperature to 60 Celsius, only to have the same thing happen; cold water. It was at this time that my husband and I discovered that the unit should have come with a lager basket, by checking the online documentation. Further reading revealed a fault; upon powering up the unit, the temperature readout displayed an error code "E1" for a few seconds, and then displayed the current water temperature. Once again, the unit would not heat up, though its transducer did buzz away at some fundamental frequency - odd, since harmonics go UP, not down. So, I called Amazon on 4/12, and was basically told; "..too bad. You're out of warranty and out of luck." I was incredulous, as I have never heard of Amazon telling a customer that they were on their own because they missed the warranty date by a few days - on not only a case of factory defect, but also on a case of a product being shipped with missing parts! I told the rep that I had no interest in chasing my tail over $40, and that they could keep their cheap electronics - I had better things to do. As of the writing of this review, my VEVOR 1.3L Professional Ultrasonic Industrial Cleaner with Digital Timer 40kHz Excellent Ultrasonic Cleaning Machine 110V for Jewelry Watch Ring Coin Diamond Eyeglasses Small Parts Cleaning machine has been relocated to its permanent storage location - the trash. This review is a factual recital of my experience with "VEVOR 1.3L Professional Ultrasonic Industrial Cleaner with Digital Timer 40kHz Excellent Ultrasonic Cleaning Machine 110V for Jewelry Watch Ring Coin Diamond Eyeglasses Small Parts Cleaning" machine. Respectfully, I can neither recommend this device, and in what is a first, I must also express my extreme dissatisfaction with Amazon's customer service. The fact that the unit was shipped missing parts is by itself a condition for action on Amazon's part, at least to the extent of contacting the manufacturer, and attempting to remedy that particular situation, in favor of the customer. To manifest abject apathy over a long time customer's situation, will hardly bring Bezo's house crashing down, but as is said in old proverbs; "ROME FELL". Peace!

Rebuilding a 1973 Honda Trail 90 and this thing has been a lifesaver, got my carb components squeaky clean before my rebuild. Noisy as all get out but well worth it.

I have only had it for a couple days but I am impressed. Used it to clean all my old dirty sockets and wrenches. They look like new again. Today cleaned all the keys I carry on my keyring. Like new again. Most impressive was the two pair of old eye glasses I have for emergency or garage work. Add some degreaser and some Dawn to the water and all the dirt ,grime and paint specks are gone!!

I got mine yesterday, 07/25/2023, and it works fine. I bought it to clean my bike chain only because I used to use Kerosene to do it and it smells bad and it is toxic so I decided to try an ultrasonic machine to eliminate that kerosine of my chain cleaning equation. It works fine. Chain comes out clean enough for me. It is not intuitive to use, example: there are TWO on/off buttons on the front panel, why?????? I pressed one only and it did not started, then I pressed both and it started!!!! Why two on/off buttons????? I used the machined 4 times because if you use the basket that is included, it does not do a good job. Just don't used that basket. Put your stuff in the machine without the basket ant it will do a good job cleaning it. Max temperature is 80 degrees Celsius only. I needed more than that. I needed at least something close to 100 degrees Celsius and that is why I had to used the machine 4 times to get that chain clean enough. I wax my chain and very hot water is needed to melt the old wax mixed with dirt from past rides. Just set it up to 15 minutes and 80 degrees Celsius and used it twice to get a good cleaning of the chain (put hot water from the tap inside it to begin with), it helps a lot). Otherwise, it works great! I hope it does not stop working suddenly as it happened to some people who reported it. I will let you know if its happens. In a nutshell, It works great, not awesome cleaning, but good enough! For the price I paid, it is a good deal. To finalize I would recommend you to read the instructions carefully because it tells you what NOT to do in order to NOT break it yourself. You can not drain the water immediately after it is finished cleaning for example, you can not turn it on and put water after it and so on... Just don't do what they tell you not to and the machine will last I think... Thanks and have a nice day!

Uso Odontologico: Si lo quieres usar para tu consultorio viene bien, caben perfectamente los fórceps abiertos , yo meto todo el material de la foto y hasta cabe màs. Lo he usado por primera vez y me ha encantado, la verdad si quita toda la suciedad que puede llegar a quedar muy retenida en el instrumental, como en las bisagras de las pinzas o perforadora de dique, no le pongo 5 estrellas porque la manguera llegó con detalles , me imagino que no tiene nada que ver en el funcionamiento y también por el acabado del pegamento que se logra apreciar en el video, fuera de eso, esta excelente. Habrá que probar unos meses más el funcionamiento y actualizare la opinión.

Buen producto por el precio, lo volvería a comprar

Buenisimo para limpiar joyería y excelente para limpiar cadenas de bicicleta. Lo uso con jabón biodegradable en dilución y a altas temperaturas y funciona perfecto. Deja manchas de agua si tienes mala calidad de agua pero tienes que limpiar inmediatamente después de uso para prolongar su funcionamiento. Que puedas regular temperatura y tiempo la hace la mejor

La caja venía dañada, el producto se ve como si estuviera usado, incluso traía restos de agua, su funcionamiento cumple pero no es el mejor, por el precio hay mejores opciones. 3 días seguidos me marcaba que llega el producto y no era así, se entregó tarde

Todo bien, buen producto, solo que a mi gusto un poco grande, pero bien