BLACKHAWK! Double Stack Double Mag Case

Blackhawk stellt Gerätschaften her, die einfach funktionieren. Punkt. Ich bin sehr zufrieden mit dem Magazinhalter. Die Lieferung war schnell und unkompliziert (aus den USA, weil in Deutschland anscheinend überall vergriffen). Die Karbon-like Aufkleber hätte man sich allerdings auch sparen können. Leichter wird es dadurch nicht und den meisten Gewichtsgewinn erzielt man eher durch Bio-Tuning am eigenen Astralkörper ;-).

These are great for the Glock 17 mags I bought it for. Imagine it would work fine with other double stacks (using adjustment screw). With the belt adjustment, i can lock it into my 1.5" belt and it stays,. Would support 1.75 and smaller belts too. Very good design. It also has pass through belt loops which are much more reliable to stay on, than just a silly belt clip.

I purchased this magazine pouch to use it with multiple weapons. I wanted something that would work with my Sig 226 and also my Glock 23 and Glock 19 magazines which are two distinct sizes. When I first got this mag pouch it was set up and it easily fit the Glock magazines without any adjustment. There is an adjustment screw in the front center between the two mag pouches that allows you to adjust for the thickness of the magazines that you will be carrying. This pouch is designed for double stack magazines so do not buy this for a single stack or even a 1 ½ stack magazine. (Not for S&W Shield 9 mm or 40 cal)In my video I show multiple sizes of Glock 40 cal magazines and also 9 mm mags for a Sig 226. I show how to adjust the mag pouch. There is no spring in the mag pouch and the tension on the magazines is supplied by the natural pressure of the molded plastic of the pouch and the tension can be adjusted but using the tension screw. Some magazines may be way too tight to fit into the pouch when you first get it but just loosen the screw and push in the magazines. Let the pouch set over night and it will loosen up to fit the mags well. Plastic is easily stretched and reformed and the tension screw can always be tightened.Some people complained that they could not insert two mags facing the same way and that is also not a problem. I have had no issues with multiple types of magazines and for different gun manufacturers. I show this in my video. To me that is important as you want to draw the magazines out and have them facing the proper direction for you to quickly insert them into your weapon and reload.The magazine pouch in the video is the standard mat finish version without the fancy carbon fiber look. The carbon fiber look is added by sticking two decals, that probably cost about 15 to 20 cents apiece, onto the mat finish version and they charge you 5$ for the two decals that I believe will not hold up in rough wear. I own a set of both so I know the difference between the two and to me it is not worth the extra money.The pouch holds both magazines tightly and they are properly held into place during your activities and I have no complaints. When I inserted the Sig 226 magazines into the pouch they were so loose it was ridiculous. I simply had to tighten the tension screw until they were securely held into place. The only problem, and I show this in my video, is that I have to tighten the screw a lot and it protruded out the back of the pouch into the area where your belt would fit. It sticks out so much that it would interfere with your belt and perhaps even fray an expensive tactical belt. If I were using this pouch for only Sig magazines I would cut off the excess length of the screw so it would not rub on or touch the belt. Please see the video as I clearly show this.On the back side of the pouch is a belt flap that is held into place with two screws. You also have two belt slots through the main body of the mag pouch so if you want to remove the belt flap you can. The slots are wide enough to support the use of a 1 3/4 inch tactical belt. The belt flap does have an adjustment to allow you to use belts of varying widths up to 2 inches. The flap does have a nice hooked tip on it and it helps to lock the flap underneath your belt if you are not using the belt slots. Please see my video. The pouch is curved to fit the shape of your hip or back and to make it more comfortable. It fits the contour of your body.This is a good magazine pouch. I rated it at five stars.

I am newish to the sport of shooting, and I have not used a lot of products, but in the circle I am in I think I have some kind of informed opinion.I got two of these, they work perfectly. Easily adjust the tension for your double stack mags, so they are as tight as you'd like them to be. Attacked to my belt no problem with a friction fit (I can move the mags easily across the belt, but they do not move on their own during my circuits I run.)

4000円で買える実物です．Glockマグをベルトに付けるため購入しました．ねじでお好みのテンションに設定でき，マガジンを入れやすいのに全然落ちません．5.11のベルトに付けようと思いましたがベルト幅が足りず入りませんでした．しかしこのマグポーチならカッターやはんだごてで加工が容易です．少しの加工で入ることができました．その後マルイMk23 SOCOMのマガジンもきつめではありますがしっかり入ることが確認できました．