4 Pcs Metal Adjustable Furniture Legs 3.15-4.72 inch, Adjustable Cabinet Legs for Sofa/Bed/Chair/Couch/Dresser/Table, Heavy Duty Bed Replacement Support Legs for Bed Frame/Bed Center Slat

I appreciate that these legs were a little longer than other ones advertised. They seem to be solid and easy to adjust.

Frankly, nothing problematic with these. Do exactly as intended. Goo should quality. I am not using crushing weight for these though. Very light work.

These supports are perfect. My bedframe relied on a single screw per support wooden support, which resulted in several failing. These adjustable supports shipped quickly, included four screws per support, seem extremely sturdy, and were easy to adjust. So far no problems! Very happy with this purchase and highly recommend.

Easy to install and solid even all the way up.

They’re good! I used them as legs for a custom queen bed I built. I would say at the last inch they’re a little too wobbly, but if you’re only extending it partially then you should be fine. I drilled a pilot hole using a #8 countersink bit and it worked fine. The screws are 3/4 inch long.I would go with them again, they look great and won’t scratch floors. Just a bit wobbly when extended more than 3/4 of the full length. But for my use, it feels really sturdy.

I did not use these as intended. I used them to level platforms on a sloping hill for my grow bags. They worked quite well for this application. they are holding the weight quite well.So I would say they are very versatile.

These are exactly what I needed to replace the supports my king size bed came with. Much sturdier and adjustable to the perfect height.

I bought these to replace the plastic legs on a small 2 seat couch. The installation was very easy and it felt pretty sturdy until we flipped over the loveseat. The metal plate at the top is too thin and the screws are too short to hold it in place. 2 screws popped out while flipping the loveseat back over and the metal plate bent.I had ordered the 6 pack because I wanted to add additional support at the middle, but I had to use one f the extra legs to replace the one that bent. We had to flip the sofa mid air and lower carefully to make sure the other legs did not have the same problem. a thicker mounting plate and slightly longer screws would have prevented it from breaking.I actually like the design of the product, just do not use it on heavy furniture and be sure to lower it onto all 4 legs instead of tilting and flipping. I do not trust this in the application I used it for, but would use it on a lighter peice of furniture with no worries.