Elmer's E855 Carpenter's Wood Filler, 3.25-Ounce Tube, White

Good stuff, easy cleanup

I have been renovating my house, replacing moldings with new white casements and baseboards. I've been using a product to fill in nail holes, but it seemed (to me) to be a bit fragile. I wanted something that dries a little harder. I watched a video comparing products, and this one seemed to come out on top. Pros: Easy to apply, bonds well, doesn't shrink, true white, dries harder than what I had been using, still sands easy. Cons: Hard to tell on the white woodwork where I filled. Summary: This is now my new go-to for filling nail holes, and other small imperfections. I had to mark where I filled with painters tape so I knew where to go with the touch-up paint. Buy Again: Absolutely.

Works as expected.

The best

Nice tube dispenser. Will have to see if it lasts longer against prematurely drying out like the tubs do. Nice for filling the grain on balsa model parts. Ad a blob of it in a small medicine cup or mixing bowl, about equal part water and then brush it on both faces of the balsa, let it dry, lightly sand and you'll have nicely filled grain.

Works great I’ve been using it for years

My favorite wood filler. This product is easy to work with, dries fast and hard and is easy to clean up. It's recommended by many woodworkers and for good reason. I've tried many products and this one is the best so far. You can get great results with or without having to sand. The container makes it easy to apply and seals well to store. It does dry fast so wetting it can increase workability. Highly recommended.

This is very difficult to use. I think it would be better if it were not in a tube. Try as I might, I could not get it to go where I needed it to go unless I pressed it in with my finger. The putty knife sometimes could be used to level it out but even that did not always work. Once it's in place, it does seem to be a good product. I just feel that it would be better in a container that would allow me to scoop it out and spread it with a putty knife.

釣り竿のコルクグリップの洲を埋めるのに使ってます。

Excellent Product ... works as Intended ... easy to use

Easy to use. I had new mdf primed skirting boards and used this product to fill the small gaps in the corners. It is easy to sand and the finish is great. Expensive but when used sparingly rather than normal filler, it works extremely well.

Best Light filler wood filler I found easy to sand goes hard but not rockhard tries fairly quickly good on the softwood and hardwood even balsawood

I've been a finisher for many years and have tried several fillers. This is my favorite. It goes on very smooth and dries quickly. I don't even sand it. I let it dry and then take a damp rag and wipe it flush off the wood work. Mind you these are small pin holes, but the paint touches up very easily. I've never noticed any shrinking. I've also used it to fill small chipped corners. It doesn't get super hard but it's solid enough to hold up if the corner isn't damaged again. It's a great product.