JENOLITE Rust Converter Spray for Metal 400 ml (13.52 fl oz). All In One Fast‑Acting Epoxy, Rust Reformer, Primer & Inhibitor. Converts Rust to a Paint‑Ready Surface. Made in Britain

Follow the directions carefully. Spray OUTSIDE. Prepare to leave whatever you're spraying OUTSIDE for a minimum of 2 days with any sprayed areas OPEN. The fumes will go away, but they are very strong. The warnings on the can make this very clear. I used it to spray rust in the spare tire well in the trunk of my car which didn't rust due to water intrusion ... nooooo - it was mice that made their home in there. Their 'biological leavings' ate through the paint and caused rust. Also applied to other various areas that made light surface rust after sanding in the process of repainting a car. Coats really nicely, had no problem putting an epoxy primer over the top of this stuff (I gave it a week). Worked exactly as advertised. The more work you put into preparing the surface, the better the product will work.

Very good and easy to use, stops rust dead in tracks

This is a good product but it’s expensive- It goes on the surface well and can be enough depending on your project.

Worked well when used on my 25+ year old car with tons of rust on nearly everything in the undercarriage area. I used this and then coated with Waxoyl paint product, and it looks very nice now.

I wish I had taken a before and after picture. I was concerned about the rust on the trailer of my camper. Very easy to apply. Dries quickly even though I gave to 48 hours to cure. It doesn't get rid of rust, but it does from what it looks like bonds it. The rust wasn't over excessive for the most part and I did sand down a few areas so the product would work. Obviously it's not a smooth surface but I was looking for a solution that I didn't have to grind and sand. I did cover over it with a rust protector. I'm really happy with how it turned out. Time will tell.

This stuff is amazing!!!!

Sticky mess. Ok if you wait a week for it to dry

This stuff is wild, sprays on, converts the rust, adheres to it, then hardens up like the resin coating I use on my 3d prints Used this to recoat part of a subframe that was starting to rust and the results are honestly better than expected even without putting a chassis coat over it

Schnelle lieferung, EXTRA gute qualität !

super produit ! forme une couche de résine qui durcit en séchant. acheté pour couvrir des soudures avant peinture, le rendu est super propre. peut s'appliquer généreusement sur un support horizontal, mais par petites couches sur un support vertical pour éviter les coulures. un petit peu cher certes, mais généralement les produits contenant de l'epoxy ne sont pas donnés .

Works fine recommended, stops rust but you need to paint

High quality rust converter spray. Nedded fir car body repairs and where you need to fight with rust. Clean the place of rust, spray it and wait to dry about 20 min. and paint. The job is done very simple.

Excellent product, easy to use and works quickly. I was previously sanding off rust by hand prior to painting and this has saved me a vast amount of time. Pictured is a carriage pole I am refurbishing, tested area on the left, untreated on the right. I will be buying it again!