KOYOFEI 5PCS Screen Protector for Elegoo Saturn 3, Saturn 4, 3D Printer Wear-Resistant Leak-Proof Screen Protector Film for Elegoo Saturn 3, Saturn 3 Ultra, Saturn 4 Ultra Resin LCD 3D Printers

Purchased for Anycubic Photon Mono M7 Pro. This is a very good and affordable set of screensavers for your 3D printer. Several screensavers I have tried were only large enough to cover the LCD screen (seen by the red line in the photo). They do the job, but if you have a puncture from a failed print (like I did) near the edge, there is a good chance that your resin could seep under the screensaver and get around the edges of the LCD screen itself -- potentially leaking into your internal components. That is why a screensaver of this size is needed (seen by the blue line in the photo). It will cover and protect nearly the entire surface of your print field, all the way out to the vat screws and posts. So don't take a chance on the smaller 10.1" versions. This is the type of screensaver my printer was originally supplied with, and you will get the best margin of safety.

Goes on smooth with no bubbles. Protects well and doesn’t affect clarity.

Everything about this pack was above expectation! I’d definitely recommend and purchase again. Works better than expected! Great value too!

Seems a tiny bit undersized for a Phrozen Sonic mighty 8k. It's best to install this *before* the tape around the LCD. Kapton tape works great for that purpose.

These are easy to install and make mistakes of resin tray leakage a worry of the past! Unfortunately, if you mess up the application you have to start over, but if you follow the instructions it's easy as can be.

Worked great. Don’t forget to get some of the black tape stuff.

The screen protector physically fits on the printer but it goes past the size of the screen to the whole size of the top of the printer, and yes it's ordered the right size. Because of the top of the printer is not perfectly fat like the screen you get air bubbles that are completely unavoidable and the screen protector bends in certain areas. the resin vat a different height than it used to be and not perfectly flat, makes it so prints do not come out correctly even after re-leveling plate

Scratched LCD but I put this on top and it has printed perfectly. About 40 items from simple medals, to single file articulated pieces. I wish I had known about these from the start.

Does not ststick. I have bubbles for almost half the screen, cant fix it any way.

Calidad y precio

Great.

Easy to install and no problem with touch screen.

great value - exactly as described