US CBB60 20uF Wire Lead Cylinder Motor Run SH Capacitor AC 450V

I bought this to try and replace a capacitor that was no longer available. The size was very specific and fit directly in place of the old capacitor.

This is larger than original, probably because it is for 240 volts. My scenario was... Motor had little power and turned slowly, could stop drill chuck with hand. When I took the original cap off, the motor would turn up to speed but backwards. Installed this and motor works normally. Easy repair.

This was an exact replacement for the one that went bad in my portable cement mixer

Run capacitor worked great but I had to file some plastic off the case in order to make it fit in the capaitor holder on my Craftsman drill press.

This capacitor was purchased to replace a failed unit on my portable air compressor. New capacitor restored functioning of air compressor and has been in service for approximately 4 weeks as of this writing. I was a little skeptical as to the quality of the product since it is manufactured in China, but I did not find any US manufactured alternatives. We'll see if it holds up.

Complete and total garbage. Only get one use before it burns up. Total waste of money. I have multiple motors that burn up constantly after one use with these capacitors. Not happy.

Used the capacitor to replace a 16UF 250 volt cap on my small drill press motor. 20 UF at 400 volts worked within the parameters. Runs the motor fine. Downside was that the capacitor was just larger than the original metal cover on the motor. Had to make a bracket to hold it on the rear of the motor.

I bougth this because i have a big fan for my garage, solder ot in and fan worked just fine no over heating or anything, just minor detail product did not came with cables, just the metal were they attach.