Ultrasonic Mist Maker Fogger 6 Heads, 5000ml/H Ultrasonic Fogger

Setting up a outside mushroom grow room and needed more humidifying. Purchased this and a 4 1/2 inch fan to build a mist humidifier. Got it set up and it fits the bill. I am able to keep a eight foot high, 7x7 foot room at 90% humidity even at 75 degrees. The oyster and lions mane mushrooms are pinning very heavily now. It is working out great.

Used it for my fog machine and it really helps the fog lay low.

These work great. Good replacement parts for an ultrasonic humidifier.

This unit works really well. I used it to make a diy ground mister for Halloween. It’s inside a tote filled with water with a waterproof fan blowing air into the tote and a dryer hose as an outlet for the mist. The mister puts out a lot of mist. It does also splash water a few inches above the water so be prepared for that. The tanks on the side are easy to adjust to get the buoyancy correct. The cord has some decent length to it. The power supply does get hot during use but not to a concerning level. After running for about half an hour the power supply measured about 98 degrees Fahrenheit. TLDR, super simple set up, great output.

I bought the 6-head one to create a smoky mountain scenery for a fish tank. I tested to see how low will it have to sit underwater for it to work. It is simple to set up. Simply connect the power cable to the adapter and plug it in. The floats are optional in my opinion. You can just have it sitting at the bottom of a bowl, or on top of a block that has enough water (water level will be mentioned below) and it will work. My initial test is in a 5-gallon bucket. The device will work when sitting in between 1 7/8 - 3 1/2 inches of water. The optimal water level is between 2 1/2 - 2 1/4 inches, where it creates the thickest smoke right after plugged in. Anything above 3 1/2 inches of water will not work, as it only spray water up from the ultrasonic plate. Anything less than 1 7/8 inches will only burn out the device quicker. The built seems strong and heavy, as it made out of seem to be stainless steel. The power adapter seems strong as well, as it made with aluminum casing. Power cable is quite long.

I used this mister for about 2 months over the halloween season. It worked great. The only issue i had was the caps on the floats don't seal well. This allows water to enter the floats & the unit will sink. I used this in a fish pond & had no issues with water that wasn't clean. I will buy another one.

Purchased this for my Halloween fog chiller. Works great, really helps with a steady stream of fog.

Used this for outdoor Halloween fog, and it works great. We have a small front yard, and I was hoping it would cover the ground a bit more than it did. That being said, it looked good and worked exactly as expected. I like that it works with just water and doesn’t require “fog juice”

It actually works.

Excellent

This thing pumps out a lot of fog once you get the floats set to the right level.