Sea Foam Concentrated Fuel Injector Cleaner,Helps clean fuel injectors & restore Injector patterns,Lubricates upper cylinders, Helps recover lost MPG & help reduce exhaust emission 155ml

I used Sea Foam in my 1982 Land Rover V8, and it made a noticeable difference. The engine had been stumbling at lower RPMs and struggling with hot starts. I added it to about half a tank of fuel, then took her out for a good hour-long spirited drive, otherwise know as an Italian tune-up!! By the end of the drive, the engine felt completely transformed — smooth, responsive, and much more refined. She's now purring like a kitten. Highly recommended!

Works well

I've used this on my car a couple of times, it's great easy to use, works quickly,great value for money.

This product seems to work as advertised, gave me a little bit better gas mileage I think, it gets to work really quickly, fairly good value for money. Although if you go by the recommended amount you're still probably better off filling up with premium fuel. Would highly recommend it though if your car is idling rough or you just like to rejuvenate the life of the car a bit.

used on two motorcycles , both fuel injected , hasn't totally cleared the low end occasional splutter on the older very low mileage bike , it did stay in a full tank of gas for a month before I went on a ride and emptied to tank , I've got another bottle and wont put it in until I can ride it immediately , the other slightly newer bike is running perfectly and the product is used as ongoing maintenance for fuel the injection system

Bought this as I suspected I had blocked injection, having owned the bike since last summer it's always had a flat spot at mid range and jerky at low speed, progressively got worse and recently run very poorly to the point I thought the bike was going to break down, before buying expensive parts I figured why not try this stuff, I have read on many Forums they love it in the U.S, so I put 4 fluid ounces in my tank and took the bike out today, after a mile of hesitation the engine burst into life and now runs beautifully, smooth and full power restored throughout the entire rev rage, I am both relieved and equally impressed with SeaFoam.

Used the item on 1.8 chevrolet . Slight improvement in MPG. But definitely noticed a smoother engine tick over. Would recommend and will use again

Most effective injector cleaner I've used. Really made a difference after 1 hour of running. Worth every penny.

Used this on my Tiger 800 and the engine seems a lot smoother and the mileage also has picked up a little. Highly recommended. Use as per instructions

I'm experimenting with this less expensive product and using it as a fuel additive to try to reduce carbon buildup on the upstream [or back-sides] of gasoline direct injection engine valves. Adding it during my gas station stops hasn't hurt engine performance and the use of the product appears to have improved gasoline mileage by at least1-2 mpg in my 2014 Hyundai Elantra. I have not physically inspected the valves. And the descriptions on this product's label do not address or claim efficacy in removing DFI valve carbon deposits. Other Sea Foam fuel additives do make claims that their use reduces carbon deposits. This Sea Foam product label says to "Use every fill up for best performance". I am aware of some competitive products that are recommended for use every 1000 miles or 5000 miles. I don't know if these recommended limited application rates for the other products are based on improving usage cost effectiveness or on avoiding potential engine damage. But, I suspect the addition frequency directions for these competitive products are intended to provide adequate control the indicated fuel quality and engine problems in a cost effective manner. I would follow label directions and only use what you need to maintain performance -> improved miles per gallon.

My 2013 Chevy Silverado was starting very very rough for about 5 seconds and then would run fine until the next cold start. Was getting many error codes, too lean, too rich etc. etc. Took it to the dealer and they suggested intake manifold gaskets and a new MEF sensor. Didn't help at all to the tune of $1,200+ later. Engine light back on after the dealer fix and took it to Autozone to use their code reader. This time it suggested a fuel injector replacement so I thought to myself why not try a bottle of this Seafoam as I have heard about it before but never thought I needed it. After adding the bottle to 15 gallons of gas at the station and driving about 40 miles roundtrip in a day. The very next day it started perfectly and the light is now off. For a $5.00 bottle of Magic stuff!!! I sure wish I would have tried that before the dealer fix.

Price

I had the dreaded check engine light come on. Our trusted mechanic said it could be the catalytic converter, might cost $2000+/-. But could try some engine cleaner. I've heard about Seafoam products and watched some videos on YouTubeube and gave it a try. Filled up the tank with gas. Pored in one bottle of Seafoam and about 3/4 of a tank the light went off. Then filled up with premium gas and half way empty the light came back on. Bought two more bottles of Seafoam and put one bottle in about 8 gallons of gas and light finally went off again and then did the same thing again and light has stayed off. Passed the yearly inspection and all is good. I hope you have the same results.