Auto Stop Start Eliminator for Toyota Tundra 2022-2026 GR Corolla IMT 2023+ | Idle Disabler/Disable/Delete/Canceller, Cancel/Close Engine A-Off Feature Automatically

I purchased the product specific for my 2026 Tundra, (Gas Only), and it works perfectly. I've had it installed for a day, so hopefully I will not need to update this review with some negative comments in a few months. Whenever I start the truck, the Stop/Start Eliminator is disabled. And of course I can press the dash button to enable it again. Pros: 1. It works as expected. 2. Simple/Easy to Install. It took me about 5 minutes to install, and I took my time since I knew the wiring harness was going to be tight on my vehicle. 3. It "Always" disables the Stop/Start system upon powering on the truck. 4. You can enable the Stop/Start system by pressing your dash Stop/Start button. 5. Cost is very reasonable, provided it lasts a few years (I'm hoping for the life of the truck). There are other products out there that cost 6X this, and unless this thing fails within a few years, it is very worth the price. Note: The product does not remember the last condition of the switch. It will always disable the Stop/Start system. To me this is not a Con. While it is a very easy installation, my specific truck and some tight wiring and I knew about that in advance. I popped the switch panel off, it came out a few inches, and I could disconnect the appropriate switch and install the device, then snap the switch panel back in place. Who is this for? Anyone who is not in Stop & Go traffic. Anyone who really hates when you pull into the driveway and you place the truck in Park, it turns off the engine and then starts it back up, ARG! then you want this. If you do enter Stop & Go traffic periodically, you could press your dash button and turn your automatic Stop/Start back on. Since I do not sit at a light longer than maybe 45 seconds, I'd rather preserve the life of my starter and battery and leave it off. My advice: Read up on how to install the device into your vehicle before purchasing. For my Tundra, it was very easy.

One month since install and it is working great. Install took me about 2 mins, just pop out the buttons using the included pry-tool and plug it in. The only thing to remember is if you remote start the vehicle when you get in you will need to either wait 40+ secs before starting the truck back up or manually press the button to turn off the auto stop/start. Other than that this thing works great!

Does the job great. Pretty common sense to set up.

Worked for 2 days (about 5 start ups) and then stopped working.

Best cheap mod to defeat the stupid auto stop/start feature! The trim removal tool is a nice touch. Installed in about a minute and it works great. Direct fit for 2025 tundra SR5

Less than 10 minutes to install. Tool provided for taking off the switch plate. Perfect fit. Super easy installation, Absolutely worth the money. No more annoying engine stopping at intersections.,

It was very easy to install and it works great. Thank you!

No instructions came with it but if you look on YouTube it shows you how to install it. To 6 minutes and it works great on my ‘26 Tundra.

So far it works perfectly. I have had it installed on my truck since it was new (roughly 6 months at the time of this review)

Stopped working

Worked sometimes, using it for IMT in GR Corolla