Auxbeam 1156 Led Bulb, Super Bright 6500K White P21W BA15S Bulbs for Backup Reverse Light, 12V-3030 SMD Chipsets Bulb with Projector, Pack of 2 (Need Resistors)

These work great on my 2010 H-D Road King. An idiot backed into my bike and shattered the prior taillight/brake light lens, but I already had another ready to go. The LED bulb in the old one is a different design, so I needed to find one that fit the 1157 socket, and this does the job very well. The Taillight and brake light are much brighter, and it looks great.

So far these bulbs are great, super bright. I'm using them for my reverse lights and they work great. Can actually see where I'm reversing. It's like having fog lamps at the back of my vehicle

Work excellently in L322 Range Rover Supercharged clear lights, match in intensity to 1157 auxbeams. Much more visible, about 2x brighter than bulbs. Coded out CM and HM checks so can't speak to that. Aren’t 70+ a bulb like the stock diadem bulbs are either. Strongly considering the ambers for my turns

They are a bit taller than origina 1156 bulbs but honestly super bright and good quality

These bulbs are bright, but they are a little long so you need the room in the housing -

Problem: These "plug-and-play" LED turn signal bulbs do not function correctly in older vehicles, specifically my 1979 Ford F-150. While the blinker flashes, the running light completely shuts off during the signal, which is a major safety and functional issue. Details: Installation was simple and seemed correct, with the bulbs fitting into the original sockets. The running lights worked normally until the turn signal was activated. When a turn signal was used, the running light on that side would completely turn off instead of alternating between running light and blinker. This is dangerous and makes the turn signals much less visible, especially at night. This is likely an electrical incompatibility issue with older vehicle systems that the product fails to address, despite being advertised as a simple installation. Conclusion: The bulbs are falsely advertised as a simple plug-and-play solution for a 1157 bulb replacement. For vintage truck owners, these are not a direct replacement and will require additional modifications, such as wiring in load resistors (which often get dangerously hot), to function properly. This is an unacceptable product for anyone expecting a straightforward install and safe operation.

Plug right in and very bright

We received them, however they do not fit on a 2005 Harley Fat Boy.

muy buenos

Exelente iluminación los recomiendo

If these are used as brake light bulbs, there is very little brightness difference between the low intensity illumination from being on for visibility at night, compared to the higher intensity when you press the brake pedal. This makes it dangerous as drivers behind you will find it harder to realize you are braking. I had to remove these bulbs and put back the regular dual filament incandescent bulbs which have a much greater brightness difference between brakes applied vs brakes not applied.

Stopped working after 6 months

Excelente iluminacion de lo mejor en focos que adquirido