Cat7 Cat6A RJ45 Pass-Through Connectors with Cable Boots Black

Great product, as long as you make the cables up and incorporate the screen/shielding when crimping down and using the right cable, u can't fault them Although for some devices the plastic shroud is a little intrusive and requires it being push back a little or the end of the plastic trimmed

Bought these as I was needing to terminate External CAT6A cable. Can confirm that these are perfectly sized for the thicker internal wires and fit into the load bar.

These work very well with Connectix Cat6a F/FTP B2ca Solid Cable 23AWG. These can be a little fiddly to fit, especially with the little xload bars, but you soon get the gist of them. I personally use with Faraday Cloth tape for the shielding drain wire. I would happily purchase these again if needed.

I’ve been making cables for 20+ years, these passthrough cables are constantly giving shorts and bad connections. The old school gen1 connectors where each cable is in an isolated sleeve is far better and they’re cheaper. I would’ve returned them if it wasn’t the hassle of printing label it and shipping it back.

Good quality product as advertised received well packaged and on time infact arrived earlier than expected. Thank you

Excellent for CAT6A cables. These are TRUE awg23 compatible. I’ve had 100% success rate with all of these using a good quality pass through crimper. It’s just a shame that they are so expensive. At £1 each you have to be very careful not to make mistakes or lose any pieces.

Perfect for outdoor cables which typically have larger copper pairs.

Was sent two packs (as ordered) one had been opened and parts were missing!

Doesn’t work. Cables gets shorted inside of the plug.

Facile à monter et de. Bonne qualité

Bien

super

un peu difficile à l'utilisation mais fait le job