VONFORN Paint Sprayer, 700W HVLP Spray Gun with Cleaning & Blowing Joints, 4 Nozzles and 3 Patterns, Easy to Clean, for Furniture, Cabinets, Fence, Walls, Door, Garden Chairs etc. VF803 Blue

Its not the same brand in the adver، returned ✋🏽.تم استلام قطعة غير مطابقة للصورة، تم ارجاع المنتج.

The rating is not really about the product. It could be great for all I know. It was advertised on Amazon UK but the device is for US users with US voltage and US plug so a non-starter in the UK.

The device burned in my hand after three minutes or less of the first use

Thank You!!! If you don't have anything like this, you REALLY should get something. Using Ready Stain of around 500' cedar fence. Used the smallest tip at vertical angle It. The fence links are around 7' high and 6' long (some a bit longer).One full tank would be able to spray 2 to 3 sections, depending on how much was put on. I did not change the flow rate dial from what it was set to, and it worked great. Never clogged once. Cleaned up very easy. The fence really looked wonderful when completed, this would be the second stain job, and it turned out a little darker but was really even. Before it was done by hand with both of us, it was pretty much me only this time. It saved the job!!. Would get this again in a heartbeat, wish i would have gotten it a lot sooner.

I really appreciate thoughtful design and this product is exemplary!First, you can take off the whole spray nozzle assembly to clean it separate from the motor. It comes with many more spray, nozzles, and each is marked with its size. No fumbling w a manual to figure it out (if you can find it). Second, This sprayer has a lot of power! I have owned many sprayers; plug-in, Wagner, battery operated etc etc. and none of them spray product like this does. I had a fence to stain (solid color and lighter over dark - grey over red), and I started out with a 3.0 nozzle as per the directions. It put out way too much stain, and I gradually stepped down until I got to the 1.5. And my fence was a breeze and it covered in one coat. Done in 2 hrs. Since it does put out a lot, I had to refill the canister about every 12 Feet, but it was much easier to refill because, Third, you can detach the whole spray assembly from the motor and it makes it much easier to remove the canister to refill it. It never clogged. The last two sprayers I had clogged before I had got even 25% of my project done. If you really need battery power, I would suggest one of those portable batteries - even the ones with the solar charging. The battery powered sprayers really aren’t worth it. they go through so many batteries regardless of how new your batteries are and even with 6 batteries lined up, i had trouble getting 20 ft of fence done. I have a solar powered battery station and I use it for a lot of my tools and for the most part (except lawn tools like sting trimmer etc) it makes a lot more sense than buying battery operated tools now.Forth: it comes with many nozzles, a brush, blower, cleaning attachments and a CAP for the paint canister so you don’t have to empty it back into the can (especially if you diluted it, right?). Wow. It’s so powerful I didn’t have to dilute my stain, which is why I was able to get one code. I’m sure. But just the thought put into this product is surprising for how things are often made these days!I completely recommend this sprayer. Look at all the 5 star reviews. This is the only one Amazon should sell.

I've used and owned other hvlp and airless sprayers before, and I am surprisingly impressed with this one, for the price. I was concerned that you can't adjust the airflow, only the fluid amount but after using it, I found that this wasn't an issue anyway. I sprayed 30 year old, painted, kitchen cabinets that had been lightly sanded and it came out as smooth as you can expect for older cabinet doors that weren't in great shape. At first, I sprayed the primer (Behr cabinet and trim primer) a little too thin. I was worried about going to heavy and getting drips and runs. but it turns out that I could have gone heavier. Then I did two coats of Sherwin Williams Emerald trim paint, alkyd enamel water-based paint. Again, the first coat was probably a little lighter than necessary but by time I put on the second coat, I did go slower to get a heavier spray and it covered very well with no runs. I did have the cabinet doors laying flat, not hanging though so that might have helped the pain level out.The paint does need to be thinned considerably. The manufacturer recommends no more than 1/2 pint of water per gallon -- I'm not sure what I used but it was closer to a 1/2 pint per quart, in order to get it thin enough. You must use the thinning funnel to test how long it takes for the paint to drain from it to make sure you have it thinned enough. I thinned it to about 50 seconds until the cup was empty. However, on the primer, I didn't thin it quite as much and the tip clogged up a couple of times and it spat out large drops of primer so had to thin it a little more.Be sure to practice if you've never used and hvlp sprayer before. Do some nice, even passes, overlapping the previous pass by 50%. Start the sprayer when it's pointed just OFF of the piece your painting and continue across and end off the other side of the piece. Do not start and stop it on the thing you're painting itself (unless it's very large, like a house or fence) otherwise it will get too heavy where you do the turn around.I'd recommend this for smaller projects: shutters, doors, garage door, cabinets, furniture, maybe a deck -- but I'd go with a much faster Airless sprayer for larger things, like a wood fence, house, shed etc. This goes slower than an airless and you'd constantly need to be filling the cup with paint to finish the project. I definitely would NOT use it to paint walls in a room, it's way slower than a roller. I'd recommend using it for a closet though, since it's more difficult to manuever a roller in a small space. It uses surprisingly little paint to get good coverage though. I used under 1 gallon to cover both sides of 27 cabinet doors, 9 drawer faces and all the cabinet faces. I was surprised that's all it used. Overall, it works great for the price but, as with anything, a lot depends on the user's experience, comfort level and willingness to learn and practice.